Safety Xpress BOLSM140 User manual

www.safetyxpress.com.au
PRODUCT INFORMATION &
INSTALLATION GUIDE
1300 049 246
Specications
SKU BOLSM140
Material Hot Dip Galvanised Steel
Colour Powder Coated Yellow with
Class 1 Red Reective Tape
Dimensions:
Height: 1300mm
Diameter:
140mm (Pole) 300mm (Base)
Wall Thickness: 3mm
Base: 4 Mounting Holes
16mm each in Diameter
Item Weight 18.6kg
Fixings
4 x FREE Mounting Bolts Includ-
ed per bollard
(standard xings kit)
Surface Mount Bollard
Installation:
1.Read all instruction steps from
beginning to end.
2.Determine exactly where the bollard
will be placed. If you are installing more
than one bollard, it is a good idea to
mark the ground to ensure that you
have a straight line to assist you with
the correct placement of your bollards.
3.Using your hammer drill, drill a guide
hole in the surface, through each hole
in the bollard using the drill bit. (This is
to mark the surface so that you know
where to continue to drill).
Tools Required:
• Hammer drill with correct sized drill bit
• Fixing kit
• The correct sized socket
• A hammer
• A hand broom or industrial vaccum
4.Remove the bollard and brush or vacuum
away the dust.
5.Continue to drill each guide hole to almost
the entire length of your xings.
6.If you are using a plastic plug component,
put it in the drilled hole and hammer in.
7.Place the bollard over the holes, line up
and place your xing in the holes and
screw or ahmmer in.
8.Use your socket to tighten the screw if
applicable. Be careful not to overtighten.
22
MONTHS
MONTHS
FREE
Fixings
P
Reective

www.safetyxpress.com.au
PRODUCT INFORMATION &
INSTALLATION GUIDE
1300 049 246
Technical Drawing
SKU: BOLSM140
Surface Mount Bollard
140mm x 1300mm
3mm Wall Thickness