Samsung AW2402B User manual

DB98-15116A(1)
AW2402B
Window-type Room Air Conditioner
(Cool)
ES
OWNER’S
INSTRUCTIONS

E-2
The following safety precautions must be taken when installing
and using your air conditioner.
Safety Precautions
1 The air conditioner must be plugged into its own specific power source, which must be
installed in compliance with national wiring, earthing and safety regulations.
Depending on national regulations and your specific installation, you may need to install:
A circuit breaker
For further information on electrical requirements, contact a professional electrician.
This device must be installed according to the national electrical rules.
2 Make sure that the unit is correctly ventilated at all times;
do NOT place clothing or other materials over it.
4 Do NOT insert anything between the air outlet blades, as it may damage the inner fan
and you may get hurt. Keep children away from the unit.
5 If the supply cord is damaged, it must be replaced by the manufacturer , its service agent
or similarly qualified persons in order to avoid a hazard.
6 Do NOT attempt to repair the unit yourself. If it is damaged in any way, contact:
An authorized service center
The dealer from whom you purchased the air conditioner.
7 Do NOT place any blocking objects in front of the unit.
3 NEVER spill liquids of any kind into the unit.
Should this happen, unplug the unit and contact your installation specialist.
8 If the remote control will not be used for a long time, remove the batteries.
9 Before throwing out the device, it is necessary to pull back the battery cells
and get rid of them safely .
10 The appliance is not intended for use by young children or infirm person without supervision;
young children should be supervised to ensure that they do not play with the appliance.
11 Do NOT use an extension cord with this product.
The manufacturer does not assume responsibility for accidents or injury
caused by an incorrectly installed air conditioner. If you are unsure about
installation, contact an installation specialist.
CC
CCAA AAUU UUTT TTII IIOO OONN NN

E- 3
Contents
PREPARING YOUR AIR CONDITIONER
Safety Precautions ......................................................................................... 2
Description of Each Component .................................................................... 4
Remote Control - Buttons .............................................................................. 5
Getting Started ............................................................................................... 6
Inserting the Remote Control Batteries .......................................................... 7
OPERATING YOUR AIR CONDITIONER
Cooling Your Room ........................................................................................ 8
Ventilating Your Room ..................................................................................... 9
Removing Excess Humidity ............................................................................ 10
Adjusting the Air Flow Direction Horizontally .................................................. 11
Adjusting the Air Flow Direction Vertically ...................................................... 11
PROGRAMMING YOUR AIR CONDITIONER
Setting the On Timer ...................................................................................... 12
Setting the Off Timer ...................................................................................... 13
Setting the Sleep Timer .................................................................................. 14
Selecting Energy Saving mode ...................................................................... 15
RECOMMENDATIONS FOR USE
Temperature and Humidity Ranges ................................................................ 16
Cleaning Your Air Conditioner ........................................................................ 17
Solving Common Problems ............................................................................ 18
Technical Specifications ................................................................................. 19

Temp.
Power
Swing
Fan Speed
Mode
Cool/Dry/Fan
E.Saver
Sleep
Timer
E-4
Temperature/Timer
settings
Temperature adjustment
buttons
On/Off button
Mode selection button
(Cool,Fan, Dry)
Sleep timer setting button
Timer setting button
Fan speed adjustment button Remote control sensor
Energy Saver button
Description of Each Component
The design and shape are subject to
change.
Air filter
(The air filter is
located in inside.)
Air inlet (Inside)
Air outlet
Outer air flow blades
(up/down orientation)
Air inlet (Outside)
Air outlet
Ventilation lever
Power plug (The type of
power plug may differ,
depending on the local
power supply.)
Inner air flow blades
(right/left orientation)
Temp.
Power
Swing
Mode
Cool/Dry/Fan
E.Saver
Sleep
Timer
Fan Speed

E-5
Remote Control - Buttons
Timer setting button
Temperature
adjustment buttons
Fan speed
adjustment buttons
On/Off button
Sleep timer setting
button
Mode selection
buttons
Energy Saver button
Swing
Air flow blade swing button

E-6
PRESS PUSH IMPORTANT NOTE
Getting Started
You have just purchased a Samsung window-type r oom air conditioner which should be installed
following your installation manual.
Your Owner’s Instructions contain much valuable information on using your air conditioner.
Please take the time to r ead them as they will help you take full advantage of the unit’s features.
The booklet is organized as follows.
The following figures are shown on pages 4 and 5:
-Description of Each Component
-Remote control (buttons)
They will help you find the buttons and understand the symbols displayed.
In the manual, you will find a series of step-by-step procedures for each function
available.
The illustrations in the step-by-step procedures use four different symbols:

E- 7
Inserting the Remote Control Batteries
Push the battery cover on the rear of the remote control with your thumb
in the direction of the arrow and remove it.
Insert the two batteries, taking care to respect the polarities :
+ on the battery with + on the remote control.
- on the battery with - on the remote control.
1
2
Close the cover by sliding it back until it clicks into place.
3
Use two AAA, LR03 1.5V batteries.
Do not use old batteries or different kinds of batteries together.
Batteries may be completely discharged after 12 months, even
if they have not actually been used.
You must insert or replace the remote control batteries when :
You purchase the air conditioner
The remote control does not work correctly

E-8
Cooling Your Room
To adjust the temperature, press the or buttons on the remote
control or unit one or more times until the desired temperature is displayed.
The temperature can be set between 64 ° F and 86 ° F.
Result: Each time you press the or buttons:
– The temperature is adjusted by 1 ° F and displayed on
the control panel
– The unit beeps
The air conditioner starts cooling, if the room temperature is
higher than the selected temperature.
If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
3
Press the (On/Off) button.
Result: The air conditioner starts up in the Cool mode.
The unit beeps twice.
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
Plugged in
Stopped
It will start up normally after three minutes.
If the temperature is not displayed on the control panel:
Press the button on the remote control
or
Press the button on the unit one or more times until the
temperature is displayed.
Result: The unit beeps each time you press the / button.
The air conditioner starts up in the Cool mode.
You can change modes at any time.
You must select the Cool mode if you wish to lower the temperature
in your room. You can also set the Fan speed.
1
2
To set the fan speed:
Press the , or button on the remote control as desired.
or
Press the button on the unit one or more times until the
desired Fan speed(F1, F2 or F3) is displayed.
4
To control the direction of the air flow, refer to page 11.
5
Fan!Speed
Remote Control Control Panel
Temp.
Power
Swing

E- 9
If you want to provide air circulation without cooling, you can use
the Fan mode.
If necessary, press the (On/Off) button.
Result: The air conditioner starts up in the Cool mode .
The unit beeps twice.
1
To set the fan speed:
Press the , or button on the remote control as desired.
or
Press the button on the unit one or more times until the
desired fan speed(F1, F2 or F3) is displayed.
3
To control the direction of the air flow, refer to page 11.
4
If the fan speed(F1, F2 or F3) is not displayed on the control panel:
Press the button on the remote control
or
Press the button on the unit one or more times until the fan speed
(F1, F2 or F3) is displayed.
Result: The unit beeps each time you press the / button.
The air conditioner starts up in Fan mode.
You can change modes at any time.
When the air conditioner is in the Fan mode, the temperature
cannot be set or displayed.
2
Mode
Cool/Dry/Fan
Fan!Speed
Mode
Cool/Dry/Fan
Airing Your Room
Remote Control Control Panel
Temp.
Power
Swing

E- 10
Removing Excess Humidity
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1If necessary, press the (On/Off) button.
Result: The air conditioner starts up in the Cool mode.
The unit beeps.
The air conditioner is fitted with a protection mechanism to pre-
vent the unit from being damaged when it is started immediately
after being:
Plugged in
Stopped
It will start up normally after three minutes.
2If the
temperature is not displayed at the top of the control panel, press
the button on the control panel one or more times until it
appears.
Result: The unit beeps each time you press the button.
The air conditioner runs in Dry mode.
You can change modes at any time.
3To adjust the temperature, press the or buttons one or
more times until the required temperature is displayed.
Possible temperatures are between
64 ° F and 86 ° F inclusive.
Result: Each time you press the or buttons:
- The temperature is adjusted by 1 ° F
- The unit beeps
The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
4To control the direction of the air flow, refer to page 11.
Remote Control Control Panel
Temp.
Power
Swing