Samsung SPO-100 User manual

PoE Function IP Extender
User Manual SPO-100

Copyright
©2014 Samsung Techwin Co., Ltd. All rights reserved.
Trademark
is the registered logo of Samsung Techwin Co., Ltd.
The name of this product is the registered trademark of Samsung Techwin Co., Ltd.
Other trademarks mentioned in this manual are the registered trademark of their respective company.
Restriction
Samsung Techwin Co., Ltd shall reserve the copyright of this document. Under no circumstances, this document shall
be reproduced, distributed or changed, partially or wholly, without formal authorization of Samsung Techwin.
Disclaimer
Samsung Techwin makes the best to verify the integrity and correctness of the contents in this document, but no
formal guarantee shall be provided. Use of this document and the subsequent results shall be entirely on the user’s own
responsibility. Samsung Techwin reserves the right to change the contents of this document without prior notice.
Design and specifications are subject to change without prior notice.
PoE Function IP Extender
User Manual

English _3
overview
Please read the following recommend safety precautions carefully.
yPlease do not install the device in a location where the temperature gets higher than
50 °C or lower than -10°C, nor in a location where there is a lot of rain or snow or
where humidity is high, nor in a location that is exposed to oil or gas, nor in a location
that experiences vibration or shocks, nor in an outside area, nor exposed to direct
light, nor in a location close to strong magnetism, high frequency (RF) or power
cables. Failure to comply may cause performance degradation or malfunction.
yDo not disassemble the product or introduce a foreign substance such as the metal.
yInstall only after checking the specifications and operation manual.
yNever connect a device of more than rated capacity as it can cause a fire.
(PTZ cameras, in particular, are prohibited as they consume too much power.)
yThe operating conditions appropriate for this device are -10°C to 50°C. Be cautious
when you use it commonly indoors or outdoors.
yBe careful not to mix up the wiring during installation. Refer to the UTB cable wiring
manual.
yMake sure that the IP camera supports PoE type B before using it.
yCaution is necessary as strong impact or vibration can cause a device malfunction.
ySmoke or a smell coming from the device while it is operating can lead to a fire or
electric shock.
In that case, pull off the power cable immediately and contact the place of purchase
or A/S center and receive counseling by the technical staff.
yThe UTP cable is UTP (unshielded twisted pair) indoor cable and should not be used
outdoors but STP (shielded twisted pair) is recommended for installation outdoors. If the
UTP cable is used outdoors, problems can occur with the product such as an abnormal
voltage being applied to the cable due to lightning.
yRefer to the operating manual regarding other problems or questions and contact
the A/S center if you need help from technical staff.

overview
4_ overview
CONTENTS
OVERVIEW
3
4Contents
5Product Introduction
5Product Features
5Application
6What’s Included
6Connecting the UTP cable
7At a Glance
INSTALLATION &
CONNECTION
9
9Connecting with other Device
APPENDIX
12
12 Specification
13 Product Overview

English _5
PRODUCT INTRODUCTION
This device is a single channel UTP (Ethernet Data + PoE) extender and has the built-in
power supply function (PoE) to supply the power to the camera through the UTP cable.
To overcome problems caused by the short transmission distance (100m or less) of
network equipment, it can be installed in the UTP cable section between the camera and
PoE hub, extending the transmission distance to more than 100m. Since power can be
supplied to the IP camera with PoE, the construction cost can also be saved.
PRODUCT FEATURES
ySimultaneous transmission of power and IP data to the UTP cable (CAT.5)
ySupport of TCP speed of 100Mbps Full Duplex
yEach time this device is installed, the maximum transmission distance for
Ethernet data is extended by more than 100m.
M`The number of SPO-100 systems that can be added is limited by the rated capacity of
the IP camera.
yA camera with up to 11.7W power consumption can be connected when
power is supplied through the PoE HUB.
M`Refer to the maximum extensible distance table on page11.
yBuilt-in surge-protection circuit for safety
APPLICATION
yApplication for conventional IP type or Mega Pixel camera
yArea in which an IP camera is installed within 100m of a Web Viewer
yExtended connection between the IP systems (PC or NVR)

overview
6_ overview
WHAT’S INCLUDED
Please check if your network video encoder and accessories are all included in the
product package.
Appearance Item Name Quantity
Ethernet extender 1
User Manual 1
CONNECTING THE UTP CABLE
Use the cable after checking the 4P UTP cable wiring method.
Scheme of TIA / EIA 568B
a c e gb d f h
aOrange+White Tx + eBlue+White DC 48V
bOrange Tx - fGreen Rx –
cGreen+White Rx + gBrown+White GND
dBlue DC 48V hBrown GND
J `Caution is required when working with the RJ-45 jack as above.

English _7
AT A GLANCE
Front Side
Item Description
aNetwork connection
terminal
The connection terminal of the IP camera, which uses PoE,
acts as a power supply and data port .
LED Status Status indication
YELLOW On PoE IN
Off No Power
GREEN
On Linked
Flash Data Active
Off Not Linked
a

overview
8_ overview
Rear Side
Item Description
aNetwork connection
terminal
It receives power through the PoE switching hub / PoE injector /
NVR connection terminal and transmits camera data to the NVR.
LED Status Status indication
YELLOW On 100Mbps Linked
Off 10Mbps Linked
GREEN
On Linked
Flash Data Active
Off Not Linked
J `Take care regarding to get the production connection direction right.
When connecting a PoE hub (standard type), it must be connected to the rear port RJ-45
connector in order for the PSE system to recognize it.
a

English _9
installation & connection
CONNECTING WITH OTHER DEVICE
Connecting the camera
Connect the [CAMERA] terminal of the device and video output terminal of the
camera.
Camera

installation & connection
10_ installation & connection
Connecting a product
Using a switching hub, multiple devices can be connected within the available
power range (6.3W - 11.7W) of the SPO-100.
Supplying the power through the switching hub with built-in PoE function
Installing more than two SPO-100 systems
J `The maximum extensible distance depends on the rated capacity of the IP camera,
the precise characteristics of the cable, the cable type, and the number of added
SPO-100s.
`Network link-time can increase as the number of systems increases.
Camera
PC
Extender Extender PoE Switching HUB
(Standard PoE)
Camera Extender
PC
PoE Switching HUB
(Standard PoE)

English _11
Maximum extensible distance when using the PoE HUB
Maximum
extensible
distance
PoE
extender
quantity
Camera
power
standards
Available Samsung Cameras (example)
200m 1Less than
11.7W
SNB-3002, SNB-5004, SNB-6004, SNB-6003,
SNO-7084R, SNO-6084R,
SND-3082, SND-7084, SND-7084R,
SND-5083, SND-5084,
SND-5084R, SND-6084,
SNF-8010,
SNV-6084R, SNV-7084R, SNV-3082
300m 2Less than
9W
SNB-5003, SNB-6010, SNB-7004,
SND-6083, SND-6011R,
SND-6084R,
SNO-6011R,
SNF-7010, SNF-7010V,
SNV-6013,
SNZ-5200
400m 3Less than
6.3W
SNB-5001, SNB-7001,
SND-5061, SND-7061,
J `The above maximum extensible distance is based on LS cable with CAT.5e standard
AWG24 with DC resistance (100m) 9.8Ω.
`The above maximum extensible distance may differ if the cable is not the CAT.5e
standard AWG24 cable or has a DC resistance (100m) greater than 9.8Ω.
`You can check the DC resistance (100m) value by measuring the DC resistance
(100m) for the same color cable of the UTP cable RJ45 terminal using the
cable(100m) and multimeter as shown below.
Cable (100m)
Multimeter

12_ appendix
appendix
SPECIFICATION
Items Description
Network
Data transmission speed
(TCP Rate) 100Mbps(MAX)
Data transmission method Full Duplex
Environmental Operating Temperature
/ Humidity -10°C ~ +50°C / 0% ~ 90% RH
Electrical
Applicable power (MAX.) 6.3W ~ 11.7W
Internal power consumption 1.7W Max.
Mechanical
Material Aluminum
External dimensions 88(W) x 42(H) x 25(D)mm
Weight 58g

English _13
PRODUCT OVERVIEW
Unit : mm (inch)
78 42
88
25

Samsung Techwin cares for the environment at all product manufacturing stages, and
is taking measures to provide customers with more environmentally friendly products.
The Eco mark represents Samsung Techwin’s devotion to creating environmentally
friendly products, and indicates that the product satisfies the EU RoHS Directive.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at his own expense.
Correct Disposal of This Product (Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems)
This marking on the product, accessories or literature indicates that the product and its
electronic accessories (e.g. charger, headset, USB cable) should not be disposed of with other
household waste at the end of their working life. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, please separate these items from other types of
waste and recycle them responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this product, or
their local government office, for details of where and how they can take these items for
environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the
purchase contract. This product and its electronic accessories should not be mixed with
other commercial wastes for disposal.

SALES NETWORK
SAMSUNG TECHWIN CO., LTD.
6, Pangyo-ro 319beon-gil, Bundang-gu, Seongnam-si, Gyeonggi-do, SEOUL 463-400 Rep. of KOREA
Tel : [phone], 8764 Fax : [phone]
www.samsungsecurity.com
SAMSUNG TECHWIN AMERICA Inc.
100 Challenger Rd. Suite 700 Ridgefield Park, NJ 07660
Toll Free : [phone] Direct : [phone]
Fax : [phone]
www.samsung-security.com
SAMSUNG TECHWIN EUROPE LTD.
2nd Floor, No. 5 The Heights, Brooklands, Weybridge,
Surrey, KT13 0NY, UK
Tel : [phone] Fax : [phone]
www.samsungsecurity.co.uk
www.samsungtechwin.com
www.samsungsecurity.com
www.samsungipolis.com