Savant DigiFlow 8000T User manual

| Install batteries
Slide o the cover case o the
battery room, and put into 2
AAA batteries. Then slide the
cover case back.
| Setting capacity
and timing
I®
DISPLAY
RESET
Keep pressing |
button, then press |
button and release both o the buttons. The DigiFlow
8000T will go into setting procedure. The digit will lash
to notice you that the setting procedure is on.
> Setting capacity
Press IW M ilia l button to choose the
capacity. The sequence is 0 - 100 -
200 - 300...9800 - 9900 - OFF - 0 -
100. Then press is ia a a a button to save
the ilter capacity value. Then go into
timing setting.
*The capacity mode will be disabled when you choose OFF.
» Setting timing
Press lilb ld e V l button to choose the timing.The
sequence is 0 - 30 - 60 - 90...690 - 720 - OFF - 0 - 30.
Then press to save the Timing. The setting
procedure is completed.
*The capacity mode will be disabled when you choose OFF.
*The setting procedure will be terminated, and go back to

DigiFlow 8000T
User’s Manual

the original status i there is no input or 10 seconds.
| Connecting fitting
The speci ication o the DigiFlow
8000T connectors is 3/8” NPT
emale. You could use any 3/8”
NPT male connectors.
| perating
The DigiFlow 8000T will be automatically on when there
is any water lowing through the sensor. It will automati
cally o when there is no water lowing or 10 seconds .
DISPLAY
Press DISPLAY
button:
| button is to display the status o the
three modes o the DigiFlow 8000T. showing the capaci
ty le t. Timing mode:showing the tiniing le t.Flow rate
mode:showing the current low rate. The sequence is
Flow-Rate-Timing-Capacity...
RESET button:
Press
setting-RESET button is to reset the setting to be the last
g/m

Alarm
» Noticing Alarm
When capacity is lower than 30 gallons or timing is
lower than 7 days, the buzzer will beep once and the
digit will lash to notice you to prepare changing ilter
cartridge when there is any water lowing through
DigiFlow 8000T or press the DISPLAY button.
> Warning Alarm
When capacity reaches 0 gallon or timing reaches 0
day, the buzzer will beep twice and the digit will lash to
notice you to change the ilter changing when there is
any water lowing through DigiFlow 8000T or press the
DISPLAY
» Low battery power alert
When the battery power lower than normal working
level, the buzzer will beep twice to notice you to change
thed the battery.
The data will be kept in memory when the battery power
is run out or battery is removed.