SawStop TSA-ODC User manual

Over-Arm Dust Collection
Installation Guide
For SawStop Contractor saws
with a Standard Fence Assembly
BEGIN HERE
3 mm hex key
4 mm hex key
Tools:
For all SawStop cabinet saws
and for Contractor saws with
T-Glide Fence Systems
2”
1. Slide clamps D onto tube C.
22”
C
DD
(For a Contractor saw with a
Standard Fence Assembly.)
Continue on the back side
Install brackets A by replacing the bolts on
the rear rail of the contractor saw with bolts
B in the locations shown above. Reinstall
the lock washer and nut on the end of each
bolt. Continue with steps 1-6 below.
Tools:
Two 13 mm wrenches
L-brackets
bolts
A
B
CD
(For all saws except Contractor saws
with Standard Fence Assemblies.)
AB
lower dust tube
upper dust tube
splitter
short hose
long hose
clamps with
screws
C
D
E
FG
H
D
BEGIN HERE
2”
Saw
Stop
rear rail
WARNING: This product can expose you to chemicals including wood dust, which is known to the State of California to
cause cancer. This exposure can come from drilling, sawing, sanding or machining wood products. For more information
go to www.P65Warnings.ca.gov/wood.
Model: TSA-ODC

Item Description Part number Qty
A L-Bracket TSA-ODC-001 2
B M8x1.25x20 Hex Head Bolts TSA-ODC-002 2
CLower Dust Tube TSA-ODC-003 1
D1 Dust Tube Clamp TSA-ODC-004 2
D2 M6x1x30 Button Head Screw TSA-ODC-005 2
D3 M6x1x10 Set Screw TSA-ODC-006 2
E Dust Port Splitter TSA-ODC-007 1
FUpper Dust Tube TSA-ODC-008 1
G Short Dust Hose (without hose connectors) TSA-ODC-009 1
H Long Dust Hose (without hose connectors) TSA-ODC-010 1
I 1.5” Hose Connector TSA-ODC-011 4
- SawStop Label (installed on upper metal tube) TSA-ODC-012 1
hose connector
(placed on each end of hose)
D2
D3 D1
I
2. Position clamps D on rear rail or brackets
and tighten set screws.
3 mm
hex key
C
D
D
rear rail
4 mm hex key
3. Tighten the screws that clamp tube C.
4. Slide splitter E onto the dust port at rear of saw oriented as shown below.
EE
(for a cabinet saw) (for a contractor saw)
5. Insert tube F into tube C.
F
C
Connect hoses.
6.
G
H
Contractor saw: make sure hose clears motor as the
blade moves through its full range of elevation and tilt.
IG CNS CAB 19 0001 00