Saxby Lighting Glimpse Wall Manual

Glimpse Wall
72360
Instruction leaflet
Care and Safety
•We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could
damage the finish.
•For your safety, always switch off the supply before cleaning.
Iss .2 15/10/2018
WWW.saxbylighting.com Saxby lighting. BH23 3PE
Wiring
Having correctly identified the wiring from your existing light fitting, pull the wire through the hole and connect to the
connection block inside the product in the following way:
Check that...
• You have correctly identified the wires.
• The connections are tight.
• No loose strands have been left out of the connection
block.
• When completed, ensure that there are no bare or
loose strands of wire exposed, and cover all exposed
areas of the connection block with 2 layers of
insulation tape.

Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warning
Technical data
Please read these instructions carefully before
commencing any work.
This light fitting should be connected to a fused
circuit.
The mains supply cable must have a minimum cross
sectional area of 1.0mm².
This product is suitable for installation on surfaces
with normal flammability e.g. wood, plasterboard
and masonry. It is not suitable for use on highly
flammable surfaces (e.g. polystyrene, textiles).
If mounting, note the position of the "This Way Up"
label on the back of the product and ensure it is
correctly oriented.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
This unit must be fitted by a competent and
qualified electrician.
Check the pack and make sure you have all of the
parts listed.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting.
Ensure other persons cannot restore the electrical
supply without your knowledge.
Install in accordance with IEE Wiring regulations
and current Building Regulations.
Supply
Bulb Type:
Voltage: 240V~, 50 Hz
LED (8W) SMD2835,4150K
The light source of this luminaire is not replaceable; when the light source reaches its end of life
the whole luminaire shall be replaced.
Conformity with all relevant EC Directive requirements.
Waste electrical products should not be disposed of with household waste.
Class I product, must be connected to earth.
Please recycle where facilities exist.Check with your Local Authority or
local store for recycling advice.
This product is not suitable for dimming.
Splash-proof
Installation
Layout
Existing fittings must be completely removed before installation of a new product. Before removing the
existing fitting, carefully note the position of each set of wires.
•Plan the desired layout of these fittings carefully, ensuring the cables will reach the distances each
light fitting.
Suitable for indoor and outdoor use.
•Avoid locating any cables in positions that would
cause a hazard. Position cables and junction
boxes (not supplied) away from areas where
they may be at risk from being cut, trapped
or damaged.
•
If this unit is being fitted in a room containing
a bath or shower, a 30mA RCD must be used
- in accordance with IEE regulations.
•
This product is suitable for use in living areas,
Bathroom Zone 2 and outsides of zones.
•
•Note that the switch is turned off before installation.
IP44
If replacing an existing fitting, make a careful note of
the connections.
Cables must be protected using suitable conduit or
plastic trunking.
225cm
60cm240cm
60cm
radius
from tap
ZONE 1
ZONE 0
ZONE 2
ZONE 2
Bathroom Zones Diagram
E
C
D
L N
B
D
L N
1. 2.
3. 4.