Saxby Lighting Merle 60898 Manual

• Attach the mirror to the wall by locating over the
screw heads. Ensure the screw heads are fully
engagedintothehangingslots.
• Replacefuseor circuitbreaker andswitch on.Your
lightisnowreadyforuse.
• ActivateyournewLEDmirrorbyswipingyourhandin
frontofthesensor.
Commissioning
Instructionleaflet
Merle Mirror
60898
www.saxbylighting.com
Wasteelectricalproductsshouldnotbedisposedofwithhouseholdwaste.Pleaserecyclewherefacilities
exist.CheckwithyourLocalAuthorityorretailerforrecyclingadvice.
Recycling advice
Safety information
SaxbyLighting.BH233PE
• Werecommendcleaningwithasoftdrycloth.Do
notusesolventsorabrasivecleanersasthesecould
damagethefinish.
• Mirror–Useadampclothoraproprietyglass
cleaner.Donotuseabrasivematerialsasthesewill
damagethefinish.
Live Voltages may be present in this unit even when turned of or when completely disconnected.Foryoursafety,
alwaysswitchoffthesupplybeforechanginglightbulbs,orcleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
Iss.102072015
Havingcorrectlyidentifiedthewiringfromyourexisting
lightfitting,fitthecableintothecableclampandthrough
theblackrubbergrommet.Connecttotheconnection
blockinsidetheproductinthefollowingway:
Wiring
Check that...
• Youhavecorrectlyidentifiedthewires
• Theconnectionsaretight
• Noloosestrandshavebeenleftoutoftheconnection
block.
• Thecableclampissecuredoverthecable.

Thankyouforpurchasingthislightfitting.Pleasereadtheinstructionscarefullybeforeusetoensuresafeand
satisfactoryoperationofthisproduct.Pleaseretaintheseinstructionsforfuturereference.
Warning
This is a Class 1 product and must be earthed
Pleasereadtheseinstructionscarefullybefore
commencinganywork.
Thisunitmustbefittedbyacompetentandqualified
electrician.
InstallinaccordancewithIEEWiringregulationsand
currentBuildingRegulations.
Topreventelectrocutionswitchoffatmainssupply
beforeinstallingormaintainingthisfitting.Ensure
otherpersonscannotrestoretheelectricalsupply
withoutyourknowledge.
Thislightfittingshouldbeconnectedtoafusedcircuit.
Ifreplacinganexistingfitting,makeacarefulnoteof
theconnections.
Thissystemcontainsnon-replaceablepartsand
cannotbeserviced.Ifdamageoccursthepartshould
bescrapped.
Thisproductisnotsuitablefordimming.
ThisproductisratedatIP44.
Wasteelectricalproductsshouldnotbedisposedof
withhouseholdwaste.Pleaserecyclewherefacilities
exist.Checkwithyourlocalauthorityorretailerfor
recyclingadvice.
Specification
Voltage: 240V50Hza.c.
Lamp: 10WLED(SMD2835)-23lmperLED(144intotal)
IPrating: 44
Layout
• Planthedesiredlayoutofthisfittingcarefully,
ensuringthecableswillreachthedistancebetween
thejunctionboxandthelightfitting.
• Cablesinwallsmustbeprotectedusingsuitable
conduitorplastictrunking.
• Themainssupplycablemusthaveaminimumcross
sectionalareaof1.0mm².
• Thisproducthasspecialprotectionagainstthe
ingressofmoistureandisIP44rated.
• Thisproductisfittedwithanotouchinfra-
redswitch,helpingtokeepthemirrorclearof
fingerprints.Tooperate,simplywaveyourhandin
frontofthesensor.
Existingfittingsmustbecompletelyremovedbefore
installationofanewproduct.Beforeremovingthe
existingfitting,carefully note the position of each set
of wires.
• Theinstallationofthisproductwillbeeasierwiththe
helpofanassistant.
•Usingtheholespacingdimensionsdetailedbelow,
markanddrillthefixingholes.Takecaretoavoid
damaginganyconcealedwiringorpipes.Fitthewall
plugsandsuppliedscrews.Ensurethescrewheads
protrudefromthewallaround3mmasshowninFig
A.Ensurethescrewholesareaccuratelylocatedin
thewall,asthemirrorwillhangfromthescrews.
• Wireasdetailedoverleaf.
Installation
ThisproductissuitableforuseinZone
2andoutsideZonesofabathroom.
Seediagram.Ifthisunitisbeing
fittedinaroomcontainingabathor
shower,a30mARCDmustbeused,
inaccordancewithIEEregulations.
445
500
Hole Spacing Dimensions Fig. A