SBI AC01364 User manual

45754A
Printed in Canada 12-06-2014
INSTRUCTIONS FOR FIRE SCREEN
AC01364
INSTALLATION
INSTRUCTIONS

2
WARNING: This installation may be sensitive to air draft and smoke back draft. Therefore it is
not recommended to install the fire screen with a chimney installation that is less than 20 ft
(6.1m).
To avoid burns caused by the heat from the fireplace, always wear gloves when handling the
fire screen.
You may install a fire screen on the fireplace to recreate an ambient fire. Never start a fire
with the fire screen in place; this could cause smoke spillage in the house. The fire screen
should be installed when the fireplace reaches its operating temperature (about 30 minutes
after lighting).
The accessories from this leaflet are intended for the Mundo fireplace with a serial
number 149 and less.

3
This fire screen kit includes the following:
SELF TAPPING SCREW 8-32 "F" TYPE
X 7/16" FLAT HEAD PHILLIPS BLACK
FIRE SCREEN LOCK
30021 (2X) PL66630 (1X)
TOP HINGE LOWER HINGE
PL66632 (1X) PL66633 (1X)

4
INSTALLATION
1
Insert the fire screen lock (A) into the notch at the bottom of the screen (see #1). Bend by
hand the tab and attach it underneath by means of 2 screws #30021 (B) (see #2).

5
2
Remove the door.

6
3
Remove the screws (B) from the fireplace door hinges. Install the fire screen hinges (A) and
(C) to the fireplace hinges by using the previous screws (B) that were removed.

7
4
Reinstall the door.

8
5
Install the fire screen by hanging it onto the hinges previously installed in step 3. Close the fire
screen.
WARNING: make sure the screen lock is properly adjusted to prevent any log roll back from
opening the fire screen.