
1. ON (Green) 4. DVI(Green)
On – Device ready Transmitter: Video input from DVI
Flashing – System starting up Receiver: Video output to DVI
2. LINK (Blue) 5. VGA(Blue)
On– Link connected Transmitter: Video input from VGA
Flashing- Trying to connect/ no input Receiver: Video output to VGA
3. IR (Red) 6. MSG (Red)
On – Receive IR signal On – Receive “Remote” Signal
Flashing- System warring
Button Instruction:
Reduce Number: switches channel or function number down
Increase Number: switches channel or function number up
Trouble Shooting
HDCP fail: Please use the receiver remote or front panel and enable
Menu 49 “HDCP always On” function on the receiver box.
(Press: Menu -> 49 -> Enter -> 1 -> Enter)
No display: Please force 1080p 60 Hz output on the receiver box by
pressing “Menus -> 41 -> Enter -> 3-> Enter” on the receiver remote
or front panel.
Make sure the Transmitter & Receiver are on the same Channel
Reset to Default: Menu -> 333 -> Enter
Point to Point Application
Step 1. Setup the Remote
Note: This remote can only control either Tx or Rx.
This Process only sets up the remotes.
You don’t have to point the remote to the devices.
Transmitter (Tx) Receiver (Rx)
Press ○
Φ&○
7 at the same time Press ○
Φ&○
8 at the same time
*MSG light will light when receive remote signal
Step 2. Plug and Use
If there are multiple systems on the same network, please make sure each
pair is on a different channel. *Default Channel “0”
Button - + Menu
Short Press *Reduce Number *Increase Number
Menu/Cancel
Press together Enter
VDKM02B: Quick Guide
1 4
2 5
3 6