Sealey IWMH2013 User manual

INSTRUCTIONS FOR
INFRARED QUARTZ HEATER 1500W/230V
WALL MOUNTING
MODEL NO: IWMH2013
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. ELECTRICAL SAFETY
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets
and any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of
appropriate safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. You
must also read and understand the following instructions concerning electrical safety.
1.1.1. Ensure that cables are always protected against short circuit and overload.
1.1.2. Regularly inspect power supply cables and plugs for wear or damage and check all connections
to ensure that none are loose.
1.1.3. IMPORTANT: Ensure that the voltage marked on the appliance matches the power supply to be
 usedandthattheplugisttedwiththecorrectfuse-seefuseratingatright.
1.1.4. DO NOT use worn or damaged cables, plugs or connectors. Have any faulty item repaired or
replaced immediately by a competent electrician.
1.1.5. It is recommended that this heater is wired directly to a fused isolator switch. If, however, a plug
 istted,thefollowingapplies:
1.1.6. Fit a new plug according to the following instructions (UK only).
a) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.
b) Connect the BROWN live wire to the live terminal ‘L’.
c) Connect the BLUE neutral wire to the neutral terminal ‘N’.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected,
that the cable restraint is tight.
1.2 GENERAL SAFETY
WARNING!Ensuretheheaterisatleast1mfromanyobject,500mmfromtheceilingand1800mmfromoorlevel.
WARNING! This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when
they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
WARNING! If a fuse blows, ensure it is replaced with an identical fuse type and rating.
WARNING!Nevertouchtheelementglassdirectlywithngers.Useasoftcloth,otherwisethetubemaygetdamaged.
9Familiarise yourself with the applications and limitations of the heater.
9Ensure the heater is in good condition before use. If in any doubt do not use the unit and contact your Sealey dealer.
9Only use recommended attachments and parts. Using unauthorised parts maybe dangerous and will invalidate your warranty.
9 Checkthatelementguardsareinplace,undamagedandrmlyattached.
9Keep tools and other items away from the heater when it is in use.
9Keep the work area clean and clear of unnecessary items.
9Keep children and unauthorised persons away from the heater, as it gets very hot.
9Disconnect from mains and allow to cool before moving or attempting any cleaning or maintenance.
8DO NOT use this heater with timers or other devices which switch the heater on automatically.
8DO NOT get the heater wet.
8DO NOT locate the heater below the power outlet.
8DO NOT move the heater whilst in operation or even when still warm.ATERED BY COMPETENT PERSONNEL ONLY.
8DO NOT use the heater to perform a task for which it has not been designed.
NOTE: Two dark points may exist on the surface of the heating element, or the surface of the heating element may turn white during
 therstfewminutesofoperation.Thisisnormalandwillnotaffecttheperformanceoftheheater.
CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and
vulnerable people are present.
NOTE: Children of less than 3 years should be kept away unless supervised continuously.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or
installed in its intended normal operating position and they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Refer to
Instruction
Manual
Indoor use
only
Recommended fuse rating
13 Amp
IWMH2013| Issue:4 (L) 04/05/17
Original Language Version
© Jack Sealey Limited

NOTE: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
2. INTRODUCTION
Atotally dry heat, no condensation, no gas, no fumes and no smell. Reaches maximum heat output within seconds of being turned on. Highly
polishedaluminiumreectorformaximumheatefciency.Adjustshorizontallythrough45°whilemounted.Threesettingscontrolledbypullchain,
allowunittobeonfull,halforlowpower.Indicatorpanelallowseasyindenticationofsettings.Idealforindustrialordomesticapplications.
Suitable for indoor use only.
3. SPECIFICATION
Model no: ............................................................. IWMH2013
Power:.........................................................................1500W
Supply:................................................................. 230V-13A
Dimensions: ............................................455 x 100 x 180mm
Mounting bracket stand off:.......................................... 59mm
Minimum mounting height: ....................................... 1800mm
4. INSTALLATION
IMPORTANT! This heater is supplied without a plug. If it is to be installed into a bathroom or similar location it should be wired into a
 fusedisolatorswitch,otherwisea13Aplugmaybetted.Boththesetasksmustbecompletedbyacompetentelectrician.
IMPORTANT! The heater should always have a minimum clearance of 500mm from a ceiling and at least 500mm from any
perpendicular wall and 1m from any object. Ensure that mounting surface is capable of supporting the weight of the heater.
4.1.  Drillfourholesusingtheabovediagramtorefertotheirspacings(g.1).
4.2.  Usexingssuitableforthewalltype,ensuringthattheyarecapableofbearingtheweightoftheheater.
4.3.  Insertfourscrewsintothexingsandhooktheheateroverthescrewheadsandallowtheheatertodropintothekeyholeslots(g.2).
4.4.  Scribethroughsecuringlughole(g.2),removetheheateranddrillafthholeinthepositionofthescribedmarkandinsertasuitable
 xing.
4.5. Replace the heater as in and insert a screw through the securing lug
 intothexingpreparedin4.4.
5. OPERATION
WARNING! Ensure you read, understand and apply the safety instructions
in Section 1 before using the heater.
5.1. Ensure the heater is at least 1m from any object. The heater can be tilted
 from0°to45°,setittotherequiredanglebeforeswitchingtheheateron.
5.2. Pull cord once, twice or three times to select desired heat setting and a
fourth time time to turn off.
6. MAINTENANCE
6.1. Make sure the heater plug is disconnected or the heater is isolated from the
mains supply before any cleaning is attempted. Also allow the heater to
cool completely. DO NOT use water or other liquids, or harsh abrasive
cleaners to clean the heater. DO NOTtouchthecarbonbreelementswith
 ngersasthismaydamagethetube.
6.2. Clean the exterior with a soft damp cloth with some mild detergent.
6.3. To replace any of the elements or lamps, contact your authorised Sealey dealer.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
[e-mail]
01284 757500
01284 703534
Web
Fig.1
Fig.2
Environmental Protection
Recycle unwanted materials instead of
disposing of them as waste. All tools,
accessories and packaging should be
sorted, taken to a recycling centre and
disposed of in a manner which is compatible
with the environment.
When the product becomes completely
unserviceable and requires disposal, drain
off any fluids (if applicable)
into approved containers and dispose of the
product and the fluids according to local
regulations.
WEEE Regulations
Dispose of this product at the end of its
working life in compliance with the EU
Directive on
Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer
required, it must be disposed
of in an environmentally protective way.
Contact your local solid waste authority for
recycling information.
IWMH2013| Issue:4 (L) 04/05/17
Original Language Version
© Jack Sealey Limited