Sealey SPB160W User manual

31200MAH LITHIUM AC POWER PACK 160W
MODEL NO: SPB160W
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. ELECTRICAL SAFETY FOR USE OF POWER PACK
WARNING! It is the user’s responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
9You must also read and understand the following instructions concerning electrical safety.
 TheElectricityAtWorkAct1989requiresallportableelectricalappliances,ifusedonbusinesspremises,tobetestedbyaqualied
electrician, using a Portable Appliance Tester (PAT).
9The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
 thesafetyoftheapplianceoperator.Ifinanydoubtaboutelectricalsafety,contactaqualiedelectrician.
You must ensure that you:
9Inspect the Power Pack, charge cables and connectors for wear and damage to ensure items are safe before use. If worn or
damaged DO NOT use.
9Uncoil used cables between Power Pack and devices when in use.
9DO NOT pull the Power Pack from any sockets by the lead used.
8DO NOT try to take the Power Pack apart.
8DO NOT get the Power Pack wet, or use in wet, damp conditions (for indoor use only).
WARNING! Modern vehicles contain extensive electronic systems.
 YouarerequiredtocheckwiththevehicleManufacturer,foranyspecicinstructionsregardingtheuseofthistypeofequipmenton
each vehicle. No liability will be accepted for damage / injury, where this product is not used in accordance with all instructions.
1.2. BATTERY SAFETY
9Recycle or dispose of used battery as stipulated by local regulation.
9Ensure the internal battery is fully charged before initial use.
WARNING!Toreducetheriskofburnsorre:
8DO NOT attempt to open, disassemble, modify or service the battery pack.
8DO NOTcrush,puncture,shortexternalcontactsordisposeofinreorwater.
8DO NOT expose to temperatures above 60°C (140°F).
8DO NOT move/handle/use the Power Pack when it is being charged.
8DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
recharge the battery at least once every six months of non-use.
1.3. GENERAL SAFETY INSTRUCTIONS
9Familiarise yourself with the application and limitations of the Power Pack as well as the potential hazards.
9Keep children and unauthorised persons away from the working area.
9When not in use, store carefully in a safe, dry, childproof location.
9Use the cables provided with this unit only.
8DO NOT short circuit this unit and keep it way from metal objects such as coins, keys, jewellery etc.
8DO NOT pull the cables or clamps from any connections.
8DO NOT use the unit outdoors, or in damp, or wet locations and DO NOT operate within the vicinity of flammable liquids or gases.
8DO NOT use for a task for which it is not designed.
8DO NOT modify or disassemble the Power Pack.
8DO NOTdropunit.Ifunitreceivesasharpbloworisotherwisedamagedinanywayhaveitcheckedbyaqualiedtechnician.
NOTE: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
SPB160W Issue 1 08/01/20
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Electrical shock
hazard
Keep in dry area
protect from rain
Warning:
explosive
material

2. INTRODUCTION
 Poweredbylithium-iontechnology.Easilytsinagloveboxorbackpackanditbenetsfrombeingacompact,1.5kgleisureunit
which provides multiple high amperage outputs. This unit can also supply several full charges for smartphones (iPhone X;
seven charges, Samsung Galaxy Note; six charges) or two full charges for your tablet/laptop (based on an 8800Mah battery)
as well as many other devices. Supplied with both Micro USB and Type-C charging cables. Includes a small integral work light.
3. SPECIFICATION
Model No.:.......................................................................SPB160W
Dimensions (W x D x H):....................................263x115x40mm
Inputs:.....................................QC3.0 (1 x Micro USB, 1 x TYPE-C)
Outputs:...............230V~50HzAC(160WContinuous,320WPeak)
2x12V10ADC(120WMAX),StandardUSB5V/2.1A,QC3.0
(5V/2.1A,9V/2.1A,12V/1.5A),TYPE-Coutput(5V/2.1A)
Accessories:...MicroUSBCable(5V/2.1A),USBTYPE-C(9V/2.1A)
DC Car Plug-in Socket (12V/10A)
Charge Times:........................................8hrs on TYPE-C (9V/2.1A)
13hrsonMicroUSB(5V/2.1A)
4. OPERATION
4.1. CHARGING THE POWER PACK
4.1.1. InserttheMicroUSBorTYPE-Ccableintotheunit’srelevantinputport(g.1.8,g.1.9).
4.1.2. Insert other end into either a USB wall charger (not supplied), a car accessory charger (not supplied) or the USB port on a computer
(not supplied).
4.1.3. Whilecharging,theLEDindicator(g.1.2),willdisplaybatterylevel.Onelightlitindicates0-20%,allvelightslitindicates100%.
4.1.4. Oncefullycharged,theunitwillswitcho󰀨.
4.2. USING THE POWER PACK
4.2.1. TochargeUSBdigitaldevices,selectappropriatecableforyourdevice.Plugthechargingcableintoeither5V/2.1A(g.1.4),QC3.0
 (g.1.5)orTYPE-C(g.1.6)port.
4.2.2. Disconnect after use.
4.2.3. TousetheDC12Voutput,plugthecaraccessorysocketcableintotheDCoutputport(g.1.3)andinsertcharger(notsupplied)into
the accessory socket.
4.2.4. Disconnect after use.
4.2.5. PlugtheappropriatecableintotheACoutputport(g.1.1).
4.2.6. Pressandholdthepowerbutton(g.1.10)downfor3secondstoturnontheACoutput.
4.2.7. Whennishedwiththisfeature,pressandholdthepowerbutton(g.1.1)toturno󰀨theACoutput.
4.2.8. Disconnect after use.
4.3. LED WORK LIGHT
4.3.1. Doublepressthepowerbutton(g.1.10)toturnLEDon.
4.3.2. Press the power button when LED is lit to change between three modes (Normal, SOS and Strobe).
4.3.3. DoublepressthepowerbuttontoturntheLEDo󰀨.
5. MAINTENANCE
5.1. After usage recharge the unit.
5.2. After charging / usage remove all cables / connections.
5.3. Use a clean, dry cloth to wipe down the unit after use.
5.4. ` Store in clean, dry environment with ambient temperature between 4oC and 30oC.
1 AC Output
2 LED Indicator
3 Dual 12V DC Output
45V/2.1AUSBOutput
5USB Output (QC3.0)
6 TYPE-C Output
7 LED Light
8 Micro USB Input(QC3.0)
9 TYPE-C Input
10 Power button
g.1
SPB160W Issue 1 08/01/20
Original Language Version
© Jack Sealey Limited

Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack
SealeyLtd’sBatteriesProducerRegistrationNumber(BPRN)isBPRN00705.
Partssupportisavailablefortheseproducts.Pleaseemail[e-mail]ortelephone01284757500
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
SPB160W Issue 1 08/01/20