Seastar Solutions BayStar Plus User manual

© 2003 Mari e Ca ada Acquisitio I c. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmo d, B.C. Ca ada V6V 1P6 Fax: [phone] Web: www.seastarsolutions.com
INSTALLATION INSTRUCTIONS
Copy Part# 764607, Rev. E, 08/2013 Page 1 of 2
Figure A.
WARNING
Determine desired m unting p siti n f the BayStar Plus Helm
pump. Ensure that the steering wheel will n t interfere with any
ther functi nal equipment. Check f r adequate space behind
the dash. The BayStar Plus Helm Pump can be installed with the
shaft in the h riz ntal, vertical r any angle in between. The filler
plug must always be in the upperm st p siti n.
Mounting the Helm
Drilling the Hole Using the m unting plate n page 2, use the f ll wing steps
t make an accurate and clean cut int the dash.
1. Tape the template t the dash and use a center punch f r
l cating the h les n dash, r ph t c py if required t use as
a drilling template. If a photocopy is required check ALL
MEASUREMENTS as per the template to ensure that the
photocopied template is true and correct.
2. Bef re drilling the h les, check that the helm l cati n will
all w unrestricted m vement f the steering wheel.
3. Drill the 3" diameter center h le and the f ur 5/16" diameter
m unting h les, p siti ned as sh wn.
Cleaning fluids containing ammonia, acids or any other corrosive
ingredients MUST NOT be used for cleaning any part of this
Hydraulic Steering System. Failure to comply will cause serious
damage to the steering system, resulting in possible loss of
steering, causing property damage, personal injury and/or death.
3" DIA.
(76 mm)
FILLER PORT 3/4" STANDARD TAPER
1/4" NPT PORTS (4)
1/4" NC STUDS(4)
3-15/16"
(100 mm)
1-15/16"
(50 mm)
2-5/8"
(67 mm)
6-1/16" (155 mm)
4-7/16"
(113 mm)
2-5/8"
(67 mm)
HELM PUMP # HH4514

© 2003 Mari e Ca ada Acquisitio I c. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmo d, B.C. Ca ada V6V 1P6 Fax: [phone] Web: www.seastarsolutions.com
INSTALLATION INSTRUCTIONS
Copy Part# 764607, Rev. E, 08/2013 Page 2 of 2
WARNING Use self-loc ing type fasteners only; substituting non-self loc ing
fasteners can result in loosening or separation of equipment and
loss of steering control. DO NOT exceed 110 in./lbs. (12 Nm)
torque on helm and wedge nuts and bolts.
CAUTION NPT fitting installations only. Apply a liquid, Teflon based pipe
sealant onto the threads going into the helm pump and/or
steering cylinder. Tighten fitting 'HAND-TIGHT'. Using a wrench
tighten an additional 1.5 turns. Continue to tighten until
desired orientation is achieved.
If printing or photocopying of this template is required, please
chec all measurements BEFORE you drill any holes to ensure
that the template you have printed is true and correct.
CAUTION