Seconique CORONA NEST OF TABLES Maintenance manual

SEC/SH/10/19/MY3
IMPORTANT
PLEASE READ BEFORE YOU CONTINUE FURTHER
After unpacking this product please keep the original packaging in case it needs to be
returned for any reason.
.
• Never drag or push products as this could cause damage to the joints making it inferior.
• Do not place this product next to a radiator or in direct sunlight.
if subjected to heat. Therefore it is recommended that room temperature is maintained,
• Make sure any spillage is wiped off immediately.
• Do not place hot or chilled items directly on to the surface, use a place mat or marking
will occur.
• For general cleaning use a duster, and do not use detergents of any kind. However, the
surface will need to be retreated from time to time. This can be done by using block wax
(unperfumed) and rubbing it over the whole item.
carried out.
Page 1
53324(MY)

Parts List
4
Front / Rear panel(Large)
04
2
3
Top panel(Large)
1
02
02
01
Side panel(Large)
8
Leg(Large)
04
6
7
5
02
02
01
Side panel(Medium)
12
Front /Rear panel(Medium)
04
10
11
Leg(Medium)
9
02
02
01
Side panel(Small)
Front/Rear panel(Small)
Top panel(Medium)
Top panel (Small)
Leg(Small)
* Please check contents and read the instructions before commencing assembly.
* Assemble this product following the enclosed instructions carefully.
* Please take care to avoid damaging panels during assembly.
* Use of power tools to assemble this product will invalidate
any claim and damage this product making it unsafe !!!
* Please assemble on a clean soft surface to avoid damage.
Page 2
Fittings
A3,5 x 35 16
B8 x 30 60
C24
4,0 x 40
D24
E01
GLUE
Please Note:
The below highlighted parts have been stamped with
the part number to help identify them during assembly.
01
03
04
04
04
04
02
02
03
05
08
08
08
08
06
06
07
07
09
11
12
12
12
12
11
10
10
325mm
325mm
560mm 420mm
270mm
270mm
215mm
215mm
280mm
e.g
06
SEC/SH/10/19/MY3

02
D
D
D
D
D
D
C
C
C
C
C
C
C
A
A
A
A
A
Large Table
04
04
04
04
02
02
03
03
01
Page 3
01
Glue must be added to the
dowel holes on part
02, 03, 06, 07, 10 and 11
B8 x 30 60
E01
GLUE
B
E
4,0 x 40
D08
E01
GLUE
Glue must be added to the
dowel holes on part 04
E
03 04
A3,5 x 35 06
325mm
325mm 560mm
560mm
C08
06
07
10
11
* For your future reference
PO Number should be here
SEC/SH/10/19/MY3

C
C
C
C
C
C
C
Medium Table
Small Table
06
C
C
C
C
C
C
C
Page 4
05
4,0 x 40
D08
E01
GLUE
Glue must be added to the
dowel holes on part 08
E
06 07
3,5 x 35 06
A
C08
08
4,0 x 40
D08
E01
GLUE
Glue must be added to the
dowel holes on part 12
E
09 10
C08
3,5 x 35 04
A
D
D
D
D
D
D
08
08
08
08
06
06
07
07
270mm
270mm 420mm
420mm
A
A
A
A
A
05
A
A
A
A
09
D
D
D
D
D
D
12
12
12
12
10
10
11
11
215mm
215mm 280mm
280mm
SEC/SH/10/19/MY3