Security Brands 14-R433 User manual

INSTRUCTIONS RIDGE REMOTE (433 MHZ) Model 14-R433
IN THE BOX
Make sure you have everything shown here.
This remote must be paired to and used
with a Security Brands Ridge 2.0 Transceiver
(Model 14-REC20) to work correctly.
Ridge Remote Visor Clip
Button 1
LED
PROG LED
PROGRAMMING PAIR
Button
Button 2

WHAT’S WHAT
The Ridge Remote has two programmable buttons and
a status LED. Each button can be paired to a separate
transceiver or the same transceiver and set to dierent
modes of operation.
BASIC SETUP
1. On Ridge 2.0 Transceiver, hold down
PROGRAMMING PAIR button for three seconds
and release. PROG LED will light up.
NOTE: The transceiver must be powered up and
have its cover removed for this step. Please see the
instructions that came with it for help.
2. On Ridge Remote, press and hold down both
buttons and pay attention to remote LED.
www.ShopAmericanAccess.com | [phone] | [email protected]

INSTRUCTIONS
RIDGE REMOTE (433 MHZ) Model 14-R433
WARNING! AUTOMATIC GATES CAN CAUSE
SERIOUS INJURY OR DEATH!
ALWAYS CHECK THAT THE GATE PATH IS
CLEAR BEFORE OPERATING!
REVERSING OR OTHER SAFETY DEVICES
SHOULD ALWAYS BE USED!

3. When LED ashes twice, continue holding button
you want to program and release other button.
4. When LED ashes again, release button. Button is
now programmed.
5. Repeat procedure for second button if desired.
NOTE: The second button can be paired with the
same or a dierent Ridge 2.0 Transceiver.
MODE SELECTION (MOMENTARY/LATCH)
1. On Ridge Remote, press and hold down both
buttons and pay attention to remote LED.
2. When LED ashes twice, continue holding both
buttons.
3. When LED ashes twice again, continue holding
button you want to change modes on until LED
ashes multiple times to conrm mode change.
NOTE: If the relay on the Ridge 2.0 Transceiver is
already latched (on), it cannot be unlatched unless
the remote button is set to latch mode.
NOTE: If needed, follow the same procedure for the
second button.
HOW TO USE
1. Make sure you are in range of Ridge 2.0
Transceiver you want to control.
2. Press remote button paired to transceiver long
enough for LED to ash.
3. Transceiver will respond and operate gate/door.
NOTE: If the transceiver does not respond, make sure
the remote LED is ashing when a button is pressed.
If it is not, check the battery. If it still does not
respond, complete the pairing procedure again.
Two-Year Limited Warranty
Step 3 Step 4
www.ShopAmericanAccess.com | [phone] | [e-mail]