Security Camera King HD-CVI Mini Series User manual

HD-CVI Mini Series - Quick Start Guide
DVR-CVI4120ME
DVR-CVI8240ME
720P
Resolution
1yr
Warranty
Motion
Activated
Recording
PTZ
Control

2
Welcome
Thank you for purchasing our HDCVI DVR! This Quick Start Guide will help you become
familiar with your new HDCVI DVR in a very short time. Prior to installation and operation,
please read the following safeguard and warning carefully.
Important Safeguard and Warning
All installation and operationsshould conform to your local electrical safety codes. We
assume no liability or responsibility for fires or electrical shock due to improper handling or
installation. We are not liable for any problems caused by unauthorized modifications or
attempted repair or equipment. Improper battery use may result in fire, explosion, or
personal injury. When replacing the battery, please make sure to use the same model!
Note: All the installation and operations here should conform to your local
electric safety rules.
1. Check Unpacked DVR
Upon receiving your new HDCVI DVR, please check to ensure there is no visible damage.
The shipping materials used in the packaging of the DVR can protect against most
accidental damage during transportation and should be retained for any future shipping
needs. You should also check the items included with your DVR to ensure complete
packaging.
2. About Front Panel and Rear Panel
For detailed information about the function keys on the front panel and the ports in the rear
panel of your HDCVI DVR, please refer to the User’s Manual located on the resource CD.
3. HDD Installation
This series of HDCVI DVR contains only one SATA port for HDD connection. Please use
SATA HDDsof 7200rpm or higher that are not "Green" or energy conserving drives. Please
follow the instructions below for help in the physical installation of hard disk drives.
The figurers listed below are for reference only. Slight differencesmay be found on
the front or rear panel.

3
Important
zYou may connect the HDD SATA and power cable prior to installing the HDD within the
case.
zWhen removing the DVR cover, gently tip up from the rear of the unit and lift upwards to
avoid damaging the front panel clip.
4. Front Panel
The front panel is shown as in Figure 1.
1. Remove the top cover
from the DVR.
2. Loosely attach four screws
to the HDD.
3.Align the HDD with the mounting
holes in the bottom tray.
4. Flip the case over and
tighten the HDD mounting
screws
5. Ensure that the HDD is 6. Connect the SATA and power
cables to the HDD and system
board.
7. Replace the cover while
aligning the front panel clip
and lowering the back side.
8. Secure the screws in the
rear side panels.
firmly attached to the case.

4
Figure 1
Please refer to the following sheet for front panel button information.
SN Icon Name Function
1 USB port To connect USB storage device or USB mouse
2 Alarm Alarm indicator light When an alarm occurs, this light will appear red
to alert you.
3 NET Network abnormal
indicator light
If no network connection is present, this light
will appear red to alert you.
3
HDD HDD abnormal
indicator light
5 IR IR Receiver Receives input signal from the remote control.
Go to previous menu, or cancel current
operation.
6
ESC ESC When in playback, click to return to real-time
monitor mode.
One-window monitor mode, click this button to
display assistant function: PTZ control and
image color.
Backspace function when entering text.
Press for 1.5seconds to delete the previous
character before the cursor.
In motion detect setup, use the Fn and
direction keys to configure.
In text mode, click to switch between alphabetic,
numeric, special characters and upper or
lower case.
7
FN Assist
Other miscellaneous special functions.
Confirm current operation
Go to default button
8
Enter ENTER
Go to menu
9 Power button Power button, press and hold for three
seconds to shut down DVR.
Activate current control, modify setup, and then
move up and down.
Increase/decrease numeric value.
S、TUp
Down
Assistant function such as PTZ menu.
Shift current activated control,
W、XLeft
Right When in playback, click these buttons to control
playback the bar.
If an HDD error occurs or available space is below
the threshold, this light will appear red to alert you.

5
5. Rear Panel
The 4-channel series HDCVI rear panel is shown below in Figure 2.
Figure 2
The 8-channel series rear panel is shown below in Figure 3.
Figure 3
Please refer to the following sheet for detailed information.
SN Icon Name Note
1 VIDEO IN Video input port Connect to HDCVI camera,
video input signal.
2 AUDIO OUT Audio output port Connect to audio output device
such as powered PC speakers.
3 AUDIO IN Audio input port Connect to audio input device
such as powered microphone.
4 VGA VGA video output
port Connect to computer monitor or
other VGA device to view main
DVR display.
5 HDMI High Definition
Multimedia
Interface video
output port
Connect to computer monitor,
television or other HDMI device to
view main DVR display.
6 USB2.0 port Connect to USB mouse or external
storage device.
7 Network port 10/100M Ethernet port.
A RS485 positive port.
8
B
RS485
communication port
RS485 negative port.

6
9 Power input port Input 12V DC.
10
Power on-off button Power on/off button.
11 GND Ground connection.
6. Local Login
After system has booted up, the default video display is in multiple-window mode. Click Enter or
left clicking the mouse will bring up the login interface. See Figure 4.
The default (3) system accounts consist of four accounts:
z Username: admin. Password: admin. (administrator, local and remote).
z Username: 888888. Password: 888888. (administrator, local only).
z Username: 666666. Password: 666666. (user-level account for only monitor, playback,
backup and etc.).
z Username: default. Password: default. (non-interactive system user).
Note:
For security purposes, please change your password upon first logging in. Three
incorrect login attempts within 30 minutes will trigger a system alarm and five incorrect login
attempts within 30 minutes will result in the account being locked!
Figure 4
7. Web Service (Internet Explorer)
Open Internet Explorer and enter the DVR IP address in the address bar. The default IP
address for your HDCVI DVR is 192.168.1.108, you may access it by entering
http://192.168.1.108 in the address bar. Your system may present a warning asking if you
wish to install webrec.cab which is the name of the ActiveX control. Click the Yes button to
accept the installation.
If you can’t download the ActiveX file, you may need to modify your IE security settings to
allow unsigned ActiveX controls to be installed.After installation, the interface will appear as
shown in Figure 5.
Please input your user name and password. The default login name is admin and the
password is admin also.
Note: For security reasons, please modify your password after you first login.

7
Figure 5
For more detailed instructions on the operation of your HDCVI DVR,please refer to
the User’s Manual included on the resources CD.

8
Appendix Toxic or Hazardous Materials or Elements
Toxic or Hazardous Materials or Elements
Component
Name Pb Hg Cd Cr VI PBB PBDE
Sheet
Metal(Case) ○○○○○○
Plastic Parts
（Panel）○○○○○○
Circuit Board ○○○○○○
Fastener ○○○○○○
Wire and
Cable/AC
Adapter
○○○○○○
Packing
Material ○○○○○○
Accessories ○○○○○○
Note
O: Indicates that the concentration of the hazardous substance in all homogeneous materials in
the parts is below the relevant threshold of the SJ/T11363-2006 standard.
X: Indicates that the concentration of the hazardous substance of at least one of all
homogeneous materials in the parts is above the relevant threshold of the SJ/T11363-2006
standard. During the environmental-friendly use period (EFUP) period, the toxic or hazardous
substance or elements contained in products will not leak or mutate so that the use of these
(substances or elements) will not result in any severe environmental pollution, any bodily injury or
damage to any assets. The consumer is not authorized to process such kind of substances or
elements, please return to the corresponding local authorities to process according to your local
government statutes.
Note
z For detailed operation introduction, please refer to our resource CD included in your
package for the electronic version of the User’s Manual.
zThis quick start guide is for reference only. Slight differencesmay be found in the user
interface.
z All the designs and software here are subject to change without prior written notice.
zAll trademarks and registered trademarks mentioned are the properties of their
respective owners.