Securitytronix ST-PBX9DC12V10A User manual

1
INSTALLATION MANUAL
ST-PBX9DC12V10A
9-Port Power Distribution Box

2
PACKAGE CONTENTS
This package contains:
One ST-PBX9DC12V10A power distribution box with integrated power supply.
Accessories: 2 keys, extra fuses, mounting hardware and 2 thread-through rubber rings.
One installation manual.
PRODUCT DESCRIPTION
The ST-PBX9DC12V10A is a professional grade power distribution box designed to meet the
needs of the security industry. The unit provides a total of 12VDC at 10 amps to 9 distribution
ports. It includes individual status LEDs, individual port protected PTC-type output fuses, individual
port current protection, a built-in surge protector and a toroidal transformer for high efficiency, low
temperature operation.
SPECIFICATIONS
ST-PBX9DC12V10A
Specifications (Typical)
1. Input Voltage
110VAC, 60Hz
2. Output Voltage
Regulated 12VDC @ 10A
3. Output Current
Nominal 500mA per Channel –Max 1A
4. Surge Protection
Built-in
5. Input LED –RED Color
ON = Supply Normal, OFF = Power Failure
6. Output LEDs –GREEN Color
ON = Output Normal, OFF = Check Load
7. Input Connector
Screw Terminal
8. Output Connectors
Screw Terminal
9. Main Fuse
10A/250VAC
10. Fuse
1A/250VAC
11. Dimensions
9.8” (L)x8.3”(W)x3.5”(H)
12. Weight
5.3 lbs
13. Finish
Ivory Powder Coated Steel

3
INSTALLATION AND OPERATION
CAUTION: To reduce the risk of electrical shock do not remove the cover or back of this
unit. No user serviceable parts are inside.
CAUTION: To prevent electric shocks and risk of fire hazards, do not use other than
specified power source.
1. UNPACKING and HANDLING
Each unit is shipped assembled and factory tested.
Ensure that all accessories are removed from the container before discarding packing material
2. MECHANICAL INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact your distributor or SecurityTronix at 1-610-429-1511 for
assistance.
3. SPECIAL ATTENTION
a. The installer must comply with electrical safety standards
b. You must use the correctly rated power supply. An integrated 12VDC 10A power
supply is used. Use of any other power supply may cause damage to the unit.
c. Only qualified installers are allowed to install and test the power distribution box.
d. This unit is designed for INDOOR USE ONLY.
4. INSTALLATION
a. Mount the cabinet in the desired location.
b. Slide both switches to the OFF position.
c. Connect each device (e.g., CCTV camera) to the individually protected outputs
(terminal pairs “Common Power Outputs” and “Fuse Power Output”)
d. Plug the power supply into an appropriately rated AC outlet (100-240VAC, 47-63Hz).
e. Slide the cabinet switch to the ON position.
f. Slide the PC board switch to the ON position.
g. When the unit is powered up the GREEN AC LED should be on.
Troubleshooting assistance can be found on-line at www.securitytronix.com in addition to support
from SecurityTronix sales engineers at 1-610-429-151
This symbol is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions.
This symbol is intended to alert the user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a
risk of electrical shock.