Segway Ninebot KickScooter User manual

External Battery User Manual
www.segway.com V1.0

3. Install the external battery on the rail and fix it with the M4 (20mm)
screws (2 pcs), provided with this product.After they are properly
installed, block the screw holes with the rubber stopper.
2. Install the rail with the M4 (10mm) screws (3
pcs), provided with this product. Please make
sure it is properly fixed.
4. Verify that your KickScooter powers on and off.
1. Removethe three screws on the stem, as shown.
Then remove the cover near the charge port.
Follow these steps when installing a second battery pack:
1 Installing a Second Battery Pack Warning: please use the screws provided with this product only.
3 Specifications
2 Charging
Your KickScooter isfullycharged when the LED on the charger changes from red (charging) to green (trickle charge).
Close the charge port cover when not charging.
Item
External Battery
Max.Charging Voltage
Charging Temperature 32–104°F (0-40°C)
Nominal Capacity
Battery Management System
Nominal Voltage 36 VDC
42 VDC
187 Wh
Over-heating, short circuit, over-current and over-charge protection
WARNING
Do not connect the charger if the charge port or charge cable is wet.
Charge port
Close the charge
port cover when
finished.
Openthe charge
port cover.
Insert the
charge plug.
Charging step tips