4. INSERT MEDIUM FLAT HEAD WOOD SCREWS (Ø3X15mm) (8) THROUGH PREDRILLED HOLES ON
OUTSIDE OF DRAWER RIGHT PANEL (J) AND TIGHTEN INTO PREDRILLED HOLES ON ENDS OF
DRAWER FRONT PANEL (F) AND DRAWER BACK PANEL (H). SLIDE DRAWER BOTTOM PANEL (I)
INTO GROOVES ON DRAWER FRONT PANEL (F) AND DRAWER BACK PANEL (H)AND ALIGN WITH
GROOVE ON DRAWER RIGHT PANEL (J). ASSEMBLE DRAWER LEFT PANEL (G) IN SAME MANNER.
(AS SHOWN IN FIGURE 2)
(
7
)
FIGURE1 FIGURE2
5. INSERT SMALL WOOD DOWELS (7) INTO PREDRILLED HOLES ON TOP EDGE OF DIVIDER (L) AND
FIT INTO CORRESPONDING HOLES ON UNDERSIDE OF LOWER FIXED SHELF (E) AND UPSIDE OF
BOTTOM PANEL (K). INSERT T-BOLTS (4) INTO PREDRILLED HOLES BOTTOM EDGES OF UPPER
LEFTAND RIGHT SIDE PANELS (B, C). TIGHTEN LARGE MACHINE SCREWS (Ø1/4”X1-1/2”) (2)
THROUGH PREDRILLED HOLES ON UNDERSIDE OF BOTTOM PANEL (K) INTO T-BOLTS (4).
PLEASE NOTE THAT IF SCREWS DO NOT TIGHTEN, ROTATE T-BOLTS (4) SO THAT THE THREADS
OF T-BOLTS (4) ARE FACING SCREWS. (AS SHOWN IN FIGURE 3)
6. INSERT LARGE WOOD DOWELS (Ø8x30mm) (6) INTO PREDRILLED HOLES ON WOOD BARS ON
UNDERSIDE OF BOTTOM PANEL (K), THEN FIT INTO CORRESPONDING HOLES ON INSIDE OF
LOWER LEFTAND RIGHT SIDE FRAMES (M, N). INSERT LARGE FLAT HEAD WOOD SCREWS
(Ø4X25mm) (16) THROUGH PREDRILLED HOLES ON WOOD BARS ON UNDERSIDE OF BOTTOM
PANEL (K) AND TIGHTEN INTO CORRESPONDING HOLES ON INSIDE OF LOWER LEFTAND RIGHT
SIDE FRAMES (M, N). INSERT T-BOLTS (4) INTO PREDRILLED HOLES ON BACK OF CROSS BRACE
(O). TIGHTEN X-LARGE MACHINE SCREWS (Ø1/4”X2-1/4”) (3) THROUGH PREDRILLED HOLES ON
OUTSIDE OF LOWER LEFTAND RIGHT SIDE FRAMES (M, N) INTO T-BOLTS (4). PLEASE NOTE
THAT IF SCREWS DO NOT TIGHTEN, ROTATE T-BOLTS (4) SO THAT THE THREADS OF T-BOLTS (4)
ARE FACING SCREWS. (AS SHOWN IN FIGURE 4)
7. ATTACH UPPER BACK PANEL (P) INTO SLOTS ON PARTS (A, B, C, D). INSERT PAN HEAD WOOD
SCREWS (Ø2.6X10mm) (10) THROUGH PREDRILLED HOLES ON UPPER BACK PANEL (P) AND
TIGHTEN INTO CORRESPONDING HOLES ON REAR EDGES OF PARTS (A, B, C, D). ASSEMBLE
MIDDLE AND LOWER BACK PANELS (Q, R) IN SAME MANNER. (AS SHOWN IN FIGURE 5)
