Senci SC4000i User manual

Senci
Senci
Senci

GENERATOR

6

Fuel Tank Cap
Muffler
1. Fuel Valve
2. Eco Throttle
3. Engine
Electric Start Switch
4.8A AC Circuit Breaker
5. V.HZ.H
6. Socket
7. Ground Terminal
8. 12V DC Output
9. Low Oil Alarm
10. Overload Alarm Lamp
11. Output Lamp
12. Choke
3500
RUNNING WATTS
STARTING WATTS
SC4000i
INVERTER GENERATOR
4000
ELECTRIC START
BATTERY INCLUDED
ONE
TOUCH
12VDC 8.3A
ON OFF
AC 230V
GND
FUEL SWITCH
CHOKE
ECO
THROTTLE
ON
OFF
OFF
ON
START
OUTPUT
INDICATOR
OVERLOAD
ALARM
LOW OIL
ALERT
ON
OFF
ON
OFF
ENGINE
SWITCH
AC 230V
V.HZ.H

FUNCTIONS

(CONTINUED)
Fuel Valve

o
230V 50
230V
230V

screw and
Using a #2 Philips-Head screwdriver to loose
22

12L.

Before stopping the engine, turn off and unplug all electrical loads. Never start or stop the
generator with electrical devices plugged in or turned on.
Let the generator run at no-load for several minutes to stabilize internal temperatures of the
engine and generator. Generator will shut down after ALL excess fuel has been used.
5.
1. Turn the Fuel Valve to the "OFF" position.
2. Let the engine run until fuel starvation has stopped the engine. This
usually takes a few minutes.
3. Press the engine switch to the "OFF" position.
Important:
Always ensure that the Fuel Valve and the Engine Switch are in the "OFF"
postion when the engine is not in use.

14
4.3
4.2

15
4.2

16

17
Routine Inspection and Replace Every
Routine Inspection
Replace Every

18
3
5.2 Spark Plug Maintenance
The spark plug is an important engine component
and should be checked periodically.
1. Remove the screws (8 screws) ①and then
remove the cover ②.
2. Remove the spark plug cable from the spark
plug.
3. Use the spark plug tool that shipped with your
generator to remove the plug.
4. Inspect the electrode on the plug. It must be
clean and not worn to produce the spark
required for ignition.
5. Make certain the spark plug gap is 0.7 – 0.8 mm
or (0.028 – 0.031 in.).
6. Refer to the spark plug recommendation chart
when replacing the plug.
7. Carefully thread the plug into the engine
8. Use the spark plug tool to firmly install the plug.
Spark Plug Inspection
0.7 - 0.8 mm
0.028 - 0.031 in.
Spark Plug Type: F6RTC
Spark Plug Torque:
20.0 N.m (2.0kgf.m, 14.8 lbf.ft)
Spark Plug Cross Reference:
a) AutoLite -66
b) Champion –RN14YC
c) Bosh – WR9DS

19
5.3
plug and oil drain bolt.
figure 1.
figure 1
oil plug
oil plug
maintenance
oil drain bolt

20
5.4
Figure 1
(8 screws)
4. Wash the element in soapy water
squeeze filter dry in clean cloth
(NOTE:DO NOT TWIST)Figure 4.
5. Soak filter element in clean
engine oil ,squeeze the excess
oil from filter.
6. Clean air cleaner housing and
install air filter cover and screws .
T
3
4
Figure 2
Figure 3
Figure 4
3
4