EN 7
EN
Revision 08/2017Copyright © 2017, Fast ČR, a. s.
General instructions
1. General instructions
USB connector, notes on using the unit
USB memory device must be inserted directly into the unit. To
prevent data transmission failure or its interference, do not use USB
extension cables.
Electrostatic discharges may cause the unit to malfunction. In such
an event, the user must restart the unit.
Before using aUSB memory device, test its ability to communicate
with the unit, its data reading and writing speed.
To achieve maximum reading speed we recommend that you
keep disk space defragmented. Use FAT32 or NTFS file system,
single partition and without protection. If reading and writing on
the USB memory device is not continuous, undesirable effects
may occur such as partial image loss (distortions/checkering
effects) or complete image loss, audio defects, and in extreme
cases the operation will be stopped. Unexpected behaviour of the
connected flash drive, or the presence of viruses or other damaging
software may cause the functions of the appliance to stop working,
necessitating arestart.
The USB connector is the standard type and is not able to power
aUSB device with ahigh power usage (e.g. hard disk drives HDD).
Use devices with independent power supplies and power them
from their own power supplies.
The appliance was designed to achieve maximum compatibility
with memory devices. With respect to the variety of devices on
the market it is not possible to guarantee compatibility with every
USB device. In the event of difficulties, try formatting the memory
device directly in the appliance. If problems persist, use adifferent
memory device.
