Sensio Rockford SE30104TP0 User manual

SE30104TP0
IMPORTANT SAFETY
INFORMATION:
Please read these instructions carefully
before attempting to install this product. It
is advisable to keep these instructions in a
safe place for future reference.
This product must not be modified as it
may invalidate the warranty and may render
the product unsafe.
l This product should be used indoors only.
l Install on smooth flat surface.
l The wall fixings supplied are only suitable
for brick walls. for any other wall substrate
please purchase alternative wall fixings.
l The mirror should be mounted onto a
secure surface.
l When installing please take care to avoid
water pipes, joints and electrical cables.
CARE AND MAINTENANCE:
l To maintain the finish of this product,
clean with a soft cloth periodically.
l Do not use harsh chemical solvents, this
may discolour or damage the finish.
COMPONENTS
1 x Mirror.
Screws and spacers aached
TOOLS REQUIRED
1 x instrucons 4 x screws and plugs Pencil Screw driver
DIMENSIONS:
Height: 600mm
Width: 400mm
Depth: 16mm
Stud detector

This mirror is suitable
for installation in zone
1 and zone 2 and the
outside zones.
ZONE
0Inside the bath or
shower. Must be SELV
(12V max) due to water
submersion.
225cm above the bath
or shower.
1
The area stretching to
60cm outside the bath
or shower and 60cm
from water outlet
of sink.
2
Technical drawings are for illustration purposes only.
Make sure you check all hole cut outs before work commences.
INSTALLATION
When unwrapped lay
the product on a soft flat
surface/cloth with mirror
facing downwards to avoid
scratching the mirror.
Mark the position of the
fixing holes in the metal
bracket onto the wall using
a stud detector to ensure
you avoid any wiring or
water pipes.
Mark the desired height of
the mirror. Drill the required
holes and insert the wall
plugs. Note: Wall plugs
supplied are only suitable
for solid/brick walls. Please
ensure the screws are fully
tight. The mirror can be
mounted either portrait
or landscape.
1 2 3
Hang the mirror onto the brick wall.
Waste Electrical & Electronic Equipment (WEEE)
The symbol on the product, or on the document accompanying the product, the crossed
out wheelie bin symbol, indicates that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection point for the recycling of
electrical and electronic waste.