neighbor Terra In-line Half Table User manual

Have questions, comments, or feedback? Reach out at [e-mail] questions, comments, or feedback? Reach out at [e-mail]
Parts
1x In-line Half
Table Top
1x Short Corner
Table Leg
2x Long Table Leg
Two sides connected
If attaching to Armless or Arm Modules:
If attaching to Corner Module:
*Only needed if attaching
to Corner Module
1x Short Table Leg
1
1
2
Attach two Long Table Legs and two
Short Table Legs to Table Top.
Attach two Long Table Legs and one
Short Table Leg to Table Top.
6x 20mm Bolt, Spring, and Flat Washer8x 20mm Bolt, Spring, and Flat Washer
6x 20mm Bolt, Spring, and Flat Washer
TERRA COLLECTION
In-line Half Table
Assembly Guide
• Do NOT use a drill while assembling
• Assemble all parts on a soft surface
Hardware
2Attach Short Corner Table Leg to Corner Module
first, then connect modules. Adjust leveling feet.
6x 20mm Bolt, Spring, and Flat Washer from Corner Module
May need to remove
Long Leg first.
May need to
remove Short and
Long Leg first.
Connect to previously assembled module
and adjust leveling feet as needed.
Short
Table Leg
Short Corner
Table Leg
Short Leg
Replace any seating module legs with the included
table legs to match the height of the table.
Note: there will be additional Table Legs in your box
that may or may not be needed for this configuration.
See other configuration option on opposite side.
Short
Corner Leg
Important
8x 20mm Hex Bolt 8x Flat Washer8x Spring Washer 1x Allen Wrench

Have questions, comments, or feedback? Reach out at [e-mail] questions, comments, or feedback? Reach out at [e-mail]
One side connected
If attaching to Armless or Arm Modules:
If attaching to Corner Module:
TERRA COLLECTION
In-line Half Table
Assembly Guide
2Connect to previously assembled module
and adjust leveling feet as needed.
6x 20mm Bolt, Spring, and Flat Washer from adjacent module8x 20mm Bolt, Spring, and Flat Washer
1Attach a Long Table Leg, one Short Table Leg,
and two Short “L” Table Legs to Table Top.
1Attach one Long Table Leg and two
Short “L” Table Legs to Table Top.
6x 20mm Bolt, Spring, and Flat Washer
2x Short “L”
Table Leg
Parts
1x In-line Half
Table Top
1x Short Corner
Table Leg
2x Long Table Leg
*Only needed if attaching
to Corner Module
1x Short Table Leg
• Do NOT use a drill while assembling
• Assemble all parts on a soft surface
Hardware
May need to
remove Short and
Long Leg first.
2Attach Short Corner Table Leg to Corner Module
first, then connect modules. Adjust leveling feet.
6x 20mm Bolt, Spring, and Flat Washer from Corner Module
May need to remove
Long Leg first.
Short
Table Leg
Short Corner
Table Leg
Short Leg
Replace any seating module legs with the included
table legs to match the height of the table.
Note: there will be additional Table Legs in your box
that may or may not be needed for this configuration.
See other configuration option on opposite side.
Short
Corner Leg
Important
8x 20mm Hex Bolt 8x Flat Washer8x Spring Washer 1x Allen Wrench