Sensio SE30776C0 User manual

Components Tools required
Safety instrucons
Important safety instrucons
• Ifindoubtinstallaonmustbecarriedoutbyaqualiedelectrician.
• Installonsmoothatsurface(s)only.
• DonotexceedorstretchthecablelengthofeachLEDwire.
• Thereare156x0.09WwarmwhiteLEDsaroundthismirror
• (W)500mmx(H)700mmx(D)50mm
• PleasemakesuretheLEDsareworkingcorrectlybefore
 commencinginstallaon
Pleasereadtheseinstruconscarefullybeforeaempngtoinstallthis
product.Itisadvisabletokeeptheseinstruconsinasafeplaceforfurther
reference.
We recommend that you consult a qualied electrician.
All electrical installaons must be carried out in accordance
with current IEE wiring regulaons (BS7671).
Theseproductsmustnotbemodied.Ifanymodicaonsare
made,itmayinvalidatethewarrantyandmayrendertheproductunsafe.
Thisproductshouldbeusedindoors.
1xVermontLEDMirror
(screwandspacersaached)
1xinstrucons 1xPencil 1xScrewDriver
1.Beforecommencinginstallaonormaintenance,isolatethemainelectricalsupplyfortheappropriatecircuitatthefuseboard.
2.Thisproductisonlytobeconnectedtoa240V50Hzsupply.
3.Themirrorshouldbemountedontoasecuresurface.
4.Wheninstallingpleasetakecaretoavoidwaterpipes,jointsandelectricalcables.
5.Themirrormustbeinstalledwithaminimumclearanceof150mmbetweentheinfraredsensorandanyadjacentcountertop
orobstrucontoensurecorrectfunconofthesensor.
Waste Electrical & Electronic Equipment (WEEE)
Thesymbolontheproduct,oronthedocumentaccompanyingtheproduct,thecrossed
outwheeliebinsymbol,indicatedthatthisproductmaynotbetreatedashouseholdwaste.
Insteaditshallbehandedovertotheapplicablecolleconpointfortherecyclingofelectrical
andelectronicwaste.
1 x VERMONT
LED MIRROR
INSTALLATION
INSTRUCTIONS
IMPORTANT: pleasereadtheseinstruconsbeforecommencinginstallaonandretainforfuturereference.
CODE: SE30776C0

Maintenance & Care
Installaon
• Ensurethatthepowerisdisconnectedpriortocleaning.
• Tokeepthenishofthisproduct,wipeoverwithasoclothperiodically.
• Donotuseharshchemicalsolvents,thismaydis-colourordamagethenish.
SensioHouse,Unit7,SpeedwellRoad,Whitwood,Castleford,WestYorkshire,WF105PY
Technicaldrawingsforillustraonpurposesonly,Sensiohastherighttochangeanyinformaon
withoutpriornoce.Makesureyoucheckallholecutoutsbeforeworkcommences.
www.sensio.co.uk
1 x VERMONT LED MIRROR
Decideontherequiredposionforyournew
mirror,takingcaretoavoidwaterpipes,joints
andelectricalcables.Laythemirroronaat
surfacewiththefrontglasspanelfacingupwards.
Removethefourscrews,alongwiththemetal
andwhitespacerfromthebackboxusinga
Philipsscrewdriver.Carefullylithefrontglass
paneloandposionontoaat,sosurfaceto
avoidscratchingthemirrorglass.
Marktheposionofthexingholeinthemetal
backboxonthewall,avoidinganywiringor
waterpipes.Drillandpreparetheholesforthe
screws,ensuringthatthexingsareintoasolid
material,notplasterboard.Mountthemetalbox
ofthemirrorontothewallandsecureghtly.
PiercethesmallprotecveIPratedrubber
grommet(thisistoisolateandtrapanysteam
producedtoensuremaximumsafetyuse).
Usingaatbedscrewdriver,securelyconnectto
themainsupplyusingtheterminalblocksupplied
asfollows:IncomingNeutral(blue/black)to
NeutralBluewire(N)IncomingLive(brown/red)
toLiveBrownWire(L).Toacvatethedemister
pad,simplyaachthelabelledmaleandfemale
connectorstogether.Aachthefrontglass
panelsafelyontothemetalbackboxmounted
onthewall,secureghtlyusingthefourscrews,
includingthemetalandwhitespacer.Finally,
switchonthemainselectricalsupplyandpassyour
handinfrontofthesensortoacvatethelights.
132
TERMINAL
BLOCK