Furniture of America CM7952CK User manual

1 / 9
MODEL #
CM7952CK
Questions?
The Assembly Rating is a
5-point system showing the
level of effort needed to
assemble a specific product.
EASY DIFFICULT
VERSION # 21-04-28
3 - People
(Included)
Allen Wrench
Recommended
Phillips
Screwdriver
(Not Included)
GIVE US A CALL: 1-888-980-5122
MON – FRI 8:30AM – 5:30PM (PT)

2 / 9
5

PRE ASSEMBLY
INTRODUCTION
Suitable Location
Assembling near the area of the
intended location is highly
recommended.
Avoid Scratches
Use cardboard, blankets or a
carpeted area while assembling
furniture to prevent scratches.
Teamwork
ALWAYS have at least two people
to help with transporting and
assembling the product to avoid
potential injury and/or damage.
Flat Surface
Make sure the furniture rests on
a flat and level surface with each
leg evenly touching the floor.
Sufficient Space
Make sure you have enough
space to move around during the
assembly.
We understand building ready-to-assemble furniture can be a challenging
experience for some. To help avoid confusion, we have provided some helpful
tips that may speed up the process.
3/ X9

4 / XXXXX9

BED
CM7952CK
5 / 9
#A 8pcs #B 8pcs #C 8pcs
Bolt Ø5/16" x 3"
#D 1pc #F 8pcs
Screw #4 x 25mm
#1 1pc #2 2pcs #3 4pcs
Headboard
#4 2pcs
Slat support leg
167x30x30mm
Slat
#5 8pcs
Siderail
(Ø1/4")
Footboard
Hex Nut Ø5/16" Half Moon Ø5/16"
Wrench
#E x 8pcs
Flat Washer Ø5/16"

CM7952 CK is packed in 3 cases
Headboard
CM7952 CK-HB
CM7952 CK-FB Footboard
Side Rail(2pcs)
6 / 9
CM7952 CK-R
Bed Slats(4pcs)
Slat Support Leg
#1
#2
#3
#5
#4
#F x8pcs
Carton Disignation Part Hardware
#A x8pcs
#B x8pcs
#C x8pcs
#D x1pc
#E x8pcs
(8pcs)

Exploded View
#1
#2
#4
#4
#5
#3
7 / 9

ASSEMBLY INSTRUCTIONS
8 / 9
Part #1 x1pc
Part #2 x1pcs
Part #4 x2pcs
Hardware #A x8 pcs
Hardware #B x8 pcs
Hardware #C x8 pcs
Hardware #D x1 pc
Hardware #E x8 pcs #D
#B
#E
#C
#A
#4
#4
#2
#1
Part #3 x1pc
Part #5 x2pcs
#3
#5
x 4
1
2
Attach threaded bolts (#A) to the
headboard (#1) and footboard (#2),
then align side rails (#4) to the
headboard (#1) and footboard (#2).
Secure by using hex nuts (#B) with
washers (#E,C).
Attach support legs (#5) to the slats (#3).

ASSEMBLY INSTRUCTIONS
9 / 9
3
4
Hardware #E x8 pcs
#E
#1
#4
#4
#3
Align slats (#3) to the side rails
(#4), then secure by using screws
(#E).