Sensio SA10372 User manual

Installation
Instructions Product #: SA10372
IMPORTANT: Please read these instructions before starting installation and retain for future reference.
Required Materials: Required Tools :
Important Safety Information
Drill
Drill
Bit
Driver
(Sold Separately)
Scissors
Pencil
Please read these instructions carefully before attempting to install this product.
It is advisable to keep these instructions in a safe place for further reference. These products must not be modified; if
any modifications are made, it may invalidate the warranty and may render the product unsafe. These LED lights
operate on low voltage (24V). Do not wire the individual LED light fixtures directly to line power. This product is for
indoor use only. Keep out of moisture and use only in dry rooms.
The National Electrical Code (NEC) does not permit cords to be concealed where damage to insulation may go
unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be
inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any
damage is noted.
CAUTION -To reduce the risk of fire, electric shock, or injury to persons:
a) Use only insulated staples or plastic ties to secure cords
b) Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall
c) Not intended for recessed installation in ceilings, or soffits.
Driver Lead
(Sold Separately)
Staple Gun
(optional)
Screwdrive
r Bit
Flexible 16.4’ (5 meter)
24W 300 Diode IP65
Strip Light
Flexible Strip
Safety Instructions
1. Turn off the main electrical supply for the appropriate circuit
at the fuse board.
2. This product is only suitable for connecting to a 24V DC power
source.
3. Position lights where they will not be exposed to persistent
steam, splashes, etc.
4. The LEDs in this fixture cannot be replaced.
5. Suitable for under cabinet lighting, attached to a mounting
surface such as wood or laminate.
6. Failure to use surge protection in problem areas will void the
warranty.
7. Use only approved accessories.
8. IMPORTANT: Fixture must NOT be covered by insulation.
Measuring
Tape

Flexible 16.4’ (5 Meter) 24W 300 Diode
IP65\Strip Light
Installation
Sensio America
877-501-5337
www.sensioamerica.com
•Ensure that the power is disconnected prior to cleaning.
•To keep the finish of this product, wipe over with soft cloth
periodically.
•Do not use harsh chemical solvents, it may discolor or
damage the finish.
Maintenance & Care Support
Drill 5/16" hole in bottom front
corner.
1
12
Connect driver to power.
Connect to driver.
10
Staple wire in place along inside
front edge of cabinet (optional).
11
Determine placement (front,
center, or back) and use pencil to
draw line.
2
Measure line drawn. Clean surface
with rubbing alcohol and let dry.
3
Feed driver lead wire through hole up
along inside front corner of cabinet.
8
Adhere strip along line, driver lead
on side of drilled hole.
7
Feed driver lead to LED driver.
9
Attach driver lead into strip.
5
Cut excess plastic off, cut strip on
scissor line indicator.
4
Peel off backing.
6
(FRONT OF CABINET)