Serta PALERMO 2 User manual

8 of 8 Rev.04222016
PATENT PENDING
PALERMO 2
TOLL FREE 1-877-693-8866 LIFESTYLE SOLUTIONS
Insert the power plug into the power socket, then connect with your home appliances.
Connect Home Appliances
Power strip

PARTS AND HARDWARE
Avoid using sharp objects such as a knife to cut open packing as you may accidentally damage the upholstery.
7 of 8
2 of 8
Leg
1 Set
Sofa Body
1x
Splitback
Support Leg
1x
Converting Chaise
Ensure unit is in bed position. Facing sofa, lift right side of sofa seat (and backrest) to
the desired chaise position.
1/4” Nut
16x
1/4” Mini Spanner
x1
1/4” x 3/4” Bolt
16x
M4 Allen Key
1x
1/4” x 1” Bolt
2x

3 of 8
ASSEMBLY INSTRUCTIONS
CAUTION: At least two adults are required to safely complete performing this task.
Other lifting attempts may risk back injury due to large and heavy part(s).
Carefully place the sofa body unit on a flat surface with the metal frame facing up
(at least two persons required).
Unpack hardware from the zipped storage compartment.
6 of 8
Converting to Sofa
Standing at the side of the unit (from bed position), lift backrest to the desired position
and secure in place by releasing to the sound of a click.
Converting to Lounger
In bed position, lift backrest upwards with each click sound until the desired lounge
position is reached.
Converting to Bed
From sofa or lounge position, lift backrest all the way upwards until the last click is heard
which unlocks the mechanism and carefully return to a flat position.
OPERATING YOUR UNIT
PARTS AND HARDWARE
STORAGE COMPARTMENT
Power strip wire storage

5 of 8
Finally, lift and turn assembled unit on its legs (at least two persons required).
A flat configuration of the sofa indicates that it is in bed position (refer Operating
Your Unit on Page 6).
Align each of the four legs and support leg onto the designated plates on the frame
in the correct orientation as shown below.
Hold the head of bolts with your finger, screw in four bolts and four nuts using the
provided mini spanner.
4 of 8
Secure support leg onto pre-assembled center metal rail with two bolts until
firmly tight.