Serta VALENCIA User manual

U.S. PATENT NUMBER D635,793 S
8 of 8 Rev.141114
Adjusting Armrest Positions
Standing in front of the unit, lift armrest to the desired
position and secure in place by releasing to the
sound of a click.
To return to a flat position, lift armrest all the way up
to the end, releasing the locking mechanism and
carefully return to a flat position.
IMPORTANT
During conversion, ensure lifting in done on
bottom of armrest.
Splitback
Sofa with Armrest
VALENCIA
TOLL FREE 1-877-693-8866 LIFESTYLE SOLUTIONS

Sofa body
1x
1/4” Mini Spanner
1x
Front Leg
1x
Support Rail
1x
Rear Leg
1 Pair Support Leg
1x
PARTS AND HARDWARE
Avoid using sharp objects such as a knife to cut open packing as you may accidentally damage the upholstery.
2 of 8
M4 Allen Key
1x
1/4” x 1.75” Bolt
12x
1/4” x 0.75”
2x
1/4” Washer
12x
1/4” Nut
4x
7 of 8
Converting to Sofa
Standing at the side of the unit (from bed position), lift backrest to the desired position
and secure in place by releasing to the sound of a click.
Converting to Lounger
In bed position, lift backrest upwards with each click sound until the desired lounge
position is reached.
Converting to Bed
From sofa or lounge position, lift backrest all the way upwards until the last click is heard
which unlocks the mechanism and carefully return to a flat position.
OPERATING YOUR UNIT

6 of 8
Carefully lift and turn assembled unit onto its legs. A flat configuration of the sofa
indicates that it is in bed position (refer Operating Your Unit on page 7).
3 of 8
ASSEMBLY INSTRUCTIONS
CAUTION: At least two adults are required to safely complete performing this task.
Other lifting attempts may risk back injury due to large and heavy part(s).
Carefully place sofa body unit on a clean flat surface with bottom side facing up.
Align front leg as shown below and secure a long bolt and washer each using the
provided Allen key.
Secure support leg onto pre-assembled center metal rail with two short bolts until
firmly tight.

4 of 8
Remove temporary cover to expose hidden pre-drilled holes on front leg.
Place both rear legs in the correct orientation and secure front leg into each with two
long bolts and washers with nuts from inside.
Secure a long bolt and washer for rear legs to connect to center metal rail.
Do not tighten completely yet.
5 of 8
Align support rail into position and secure with two long bolts and washer at
each ends. Finally, completely tighten all bolts.
Stretch and pull the fabric cover evenly all around the legs before securing velcro.
Repeat if necessary for better fit.