Serta THOMAS User manual

TOLL FREE 1-877-693-8866 LIFESTYLE SOLUTIONS

PARTS AND HARDWARE
Avoid using sharp objects such as a knife to cut open packing as you may accidentally damage the upholstery.
2 of 8
Metal Bar
2x
Armrest
1 Pair
Sofa Cushion
1x
Storage Body
1x
Nut A
8x Nut B 2x Allen Key 1x
Large Spanner
x1 Small Spanner x1
Washer
8x Plastic Cap 8x
Threaded Rod
8x
Bolt
4x
Already attached to storage,
please see assembly step 1

3 of 8
ASSEMBLY INSTRUCTIONS
CAUTION: At least two adults are required to safely complete performing this task.
Other lifting attempts may risk back injury due to large and heavy part(s).
Carefully align sofa cushion on top of storage body unit.
Lay storage body unit on a clean flat surface cleared for assembly. Temporary remove
fitted bolts from pre-drilled holes on both sides of the storage body unit.
ENSURE ORIENTATION OF BOTH SOFA CUSHION
AND STORAGE BODY ARE AS SHOWN

4 of 8
Simply lift the sofa seat cushion up from the front. Locate the exposed fix threaded
rod inside the wrinkle.
Connect metal bar into exposed fix threaded rod as shown below and secure with
nut (B) using the large spanner. Do not tighten completely yet.
Carefully align metal bar onto the pre-drilled holes inside storage body unit as shown.
Secure two bolts for each metal bar back into pre-drilled holes using provided
Allen key. Completely tighten all bolts and nuts.

5 of 8
Screw in four threaded rods into metal plates on the inner side of armrest by hand
until about half of the thread is exposed. Repeat steps for other armrest.
Locate pre-drilled holes on the side of sofa body and match the orientation with
the correct armrest.
Now, carefully join armrest (with the four threaded rods exposed) with sofa body by
aligning and going through the four pre-drilled holes at the side of sofa body.
Secure all four threaded bolts with washers and nuts (A) from inside with small spanner,
making sure there is no movement.