long as the switch is depressed
0The appliance is switched off
1Low power
2Medium power
3Maximum power
Short-term operation
The appliance is designed to process average
domestic quantities of food; it can be
operated without interruption for a
maximum of 45 seconds, after which it
should be allowed to cool down for about a
minute.
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
operated once the blender jug and lid are
properly locked in position.
Before removing the blender jug, make sure
that the control switch is in position 0. This
also applies when fitting the blender jug to
the motor housing. If the switch is not in its
off-position (0), the motor will start
immediately.
Operation
-
Fit the blender jug to the motor housing
with its handle on the right and lock it by
turning anti-clockwise into the operation
position.
-
Put the liquid ingredients into the
blender jug. The jug has a maximum
capacity of 1500 ml.
-
Put the lid on and lock it by turning anti-
clockwise. To add ingredients during
operation, the stopper in the centre of the
lid can be removed by turning it in an
anti-clockwise direction and then lifting it
off. Do not put any objects into the
blender jug while the appliance is
operating.
-
Insert the plug into the wall outlet and
use the control switch to select the
required power setting. Depending on
the food to be processed, the appliance
may also be operated for short periods of
time with the pulse setting “P”. Do not
operate when the blender jug is empty.
-
After using the blender, switch off and
remove the plug from the wall socket.
Wait until the motor has come to a
complete standstill before removing the
blender jug. To remove the jug and the
lid, turn them in the opposite direction
from that described in the assembly
instructions.
General Care and Cleaning
●Always remove the plug from the wall
socket before cleaning the appliance.
●To avoid the risk of electric shock, do not
clean the motor housing or the power
cord with water and do not immerse
them in water. The motor housing may
be wiped with a slightly damp, lint-free
cloth.
●Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning,
and do not clean in a dish-washer.
-
For cleaning after use, fill the blender jug
with approximately 1250 ml warm water
and a mild cleaning detergent. Let the
appliance run for a short period as
described in the section Operation. Then
rinse the blender jug, lid and stopper with
fresh water. All parts must me
thoroughly dried afterwards.
Disposal Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
This product is guaranteed against defects in
materials and workmanship for a period of
two years from the date of purchase. Under
this guarantee the manufacturer undertakes
to repair or replace any parts found to be
defective, providing the product is returned
to one of our authorised service centres. This
guarantee is only valid if the appliance has
been used in accordance with the
instructions, and provided that it has not
5
