Seville Classics airLIFT OFF42630 User manual

Use Instrucons
 Roll desk into desired posion.
 Lock casters to prevent the table from rolling.
 To li, pull up on the adjustment lever.
 To lower, pull up on the adjustment lever while
pressing down on the table top.
 Release adjustment lever to lock in height.
Safety
Do not p the desk over or place upside down.
Do not place more than 35 lbs. on the desk top.
Customer Service Informaon
Telephone: [phone]
Fax: [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email: [e-mail]
Homepage: www.SevilleClassics.com
062019
STEP 5.
Align holes on BASE (D) with
COLUMN (A) making sure holes
for feet face upward.
Aach with LONG BOLTS (G)
through TOOTH WASHERS (J)
using 5 MM HEX KEY (N).
STEP 6.
Install LOCKING CASTERS (F) to
the open end of BASE (D) with
WRENCH (L).
Repeat for CASTERS (E) on the
opposite side.
Congratulaons! Enjoy your new
Mobile Desk Cart!
Model: OFF42630, OFF42631
Thank you for choosing Seville Classics! We hope that you enjoy your new
mobile desk cart. Please read through this user guide for parts list, assembly
instrucons, frequently asked quesons and contact informaon.
062019
24.5" Pneumac Sit-Stand Mobile
Laptop Computer Desk Cart

Parts List
A. Column (1)
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at
[phone] or send an email to [e-mail]
1
B. Mount (1)
H. Short bolt (11)
I. Screw (2)
C. Top (1)
D. Base (1)
E. Caster (2)
F. Locking caster (2)
G. Long Bolt (4)
J. Tooth washer (4)
K. Clip (1)
L. Wrench (1)
M. 4mm Hex key (1)
N. 5mm Hex Key (1)
4 mm
5 mm
2
STEP 1.
Remove cap from COLUMN (A).
STEP 2.
Align holes on MOUNT (B) with
top of COLUMN (A).
Aach with SHORT BOLTS (H)
using 4 MM HEX KEY (M).
STEP 3.
Aach CLIP (K) to underside of
TOP (A) with SCREWS (I).
TIP! Place desk top on so
surface like carpet when
assembling to prevent
damage to the surface.
STEP 4.
Align column assembly with
holes on rear of TOP (C).
IMPORTANT: Make sure the
orange arrows match, and the
lever ts into the CLIP (K).
Aach with SHORT BOLTS (H)
using 4 MM HEX KEY (M).
Assembly Instrucons