SFS GESIPA AccuBird Pro Instruction Manual

Daily – quick clean
Ready to go in only 3 minutes.
A quick daily cleaning is recommended if the tool is heavily used
or painted rivets are being installed. Follow these easy steps:
Weekly maintenance
A weekly cleaning of the tool is recommended if it is heavily used or
painted rivets are being installed.
1. Remove the battery from the tool.
1. Remove the battery from the tool.
2. Unscrew the head using a 14mm, 24mm or
adjustable flat wrench. Sometimes a 27mm
wrench may be required depending on tool.
2. Unscrew the head using a 14mm, 24mm or
adjustable flat wrench. Sometimes a 27mm
wrench may be required depending on tool.
3. Remove the deposits and dirt in the head.3. Remove the deposits and dirt in the head.
4. Open the jaw mechanism with two wrenches:
PowerBird®Pro & AccuBird®Pro – use 2 x 17mm
wrenches; PowerBird®& Accubird®– use a 14mm
and 17mm wrench.
5. Take the jaw out (3 pieces) and clean them
with a brush.
6. Replace rusty or blunt jaws with new ones.
4. Clean the nose tip from deposits and
sparingly lubricate or grease.
7. Grease the inside of the jaw housing. Put
jaws back in place and re-assemble
mechanism with two wrenches.
5. Re-attach the nose and the tool is ready to go!
8. Clean the front of nose piece.
9. Re-attach the head to the tool.
Tool warranty
All GESIPA®rivet tools purchased after May 1, 2013 come with a 24-month warranty, 12 months
for batteries. In each case, the conditions set forth in the instruction manual shall apply (proof
by invoice or delivery note required).
Damages resulting from natural wear and tear, overloading, use of unsuitable batteries or inex-
pert handling will be excluded from the warranty. Damages resulting from material or manu-
facturing faults will be repaired or replaced free of charge. Claims can only be accepted if the
complete riveting tool is returned to the distributor of GESIPA®.
Note: If using a BULB-TITE®nosepiece, a 12mm wrench is required.

GESIPA®
Rivet Guns
Maintenance & quick help guidelines
This guideline will help you maintain your rivet gun to ensure
proper performance over the life of the tool. Regular maintenance
will extend the service life of your high-quality GESIPA®tool.
AccuBird®Pro
AccuBird®
PowerBird®Pro
PowerBird®
US Canada
T 800 234 4533 T 866 847 5400
www.sfsintecusa.com www.sfsintec.ca
Scan the QR tages for videos
Get started &
maintenance of tool
Quick help
Mandrel not ejected
Quick help
Rivet is not set
Quick help
Red light is on
Quick checks
Tool not working? Try the following quick checks:
Battery OK? Nose piece worn?
Jaws blunt?Jaw mechanism tight?
Is the head dirty?
Correct nose piece?