Shappell Trail House 270 User manual

To Order Parts, give Part No., Description and Qty Needed.
SHAPPELL CORP., 3562 W. Jefferson Hwy., Grand Ledge, MI 48837
Toll Free [phone]
CONSUMER WARRANTY
SHAPPELL CORPORATION warrants its products against defects in material
and workmanship for (1) YEAR from date of purchase. We will provide FREE
repair or replacement, in whole or in part, at our option, for any product, found
in our opinion to be defective. If return is required, freight must be prepaid.
This warranty does not cover Freight Damage, Ordinary Wear and Tear, Abuse,
Misuse or Altered Product.
For warranty claim, send letter indicating product and explanation of defect plus
dated proof of purchase to the SHAPPELL Corp., 3562 W. Jefferson Hwy,
Grand Ledge, MI 48837.
3-7-13
REPLACEMENT PARTS
MODEL TH270-ATC
Part# Description
10527 Hub Plate
10528 Plastic Hub Insert
10550 Frame Rod - 34” Roof and Lower Side
10551 Frame Rod - 38” Upper Side
10532 Hub Body & Bolt & Strap
WARNING: Keep all Heat & Flame Sources away from the Blind Fabric. The
Fabric is Fire Retardant, it is not Fire Proof. The use of any heat source can be
extremely dangerous, both for Fire Hazard and Carbon Monoxide Emissions. The
Shappell Corporation does not endorse the use of any Heater. It is the user’s
responsibility to follow the Instructions and Warnings provided by the Heater
Manufacturer for the safe use of a particular Heater.
CARBON MONOXIDE POISONING HAZARD: This blind must be ventilated
if using an oxygen consuming heat source. DO NOT prevent fresh air from
entering blind. Failure to Ventilate blind could create a Serious Health Hazard
or Death.
MAINTENANCE: If blind is wet after use, set up until fabric is completely dry.
Never leave blind folded closed with wet fabric.
NOTICE: It is normal for fabric to have some pinholes. This does not affect
water repellency.
READ SETUP & TAKEDOWN INSTRUCTIONS BEFORE USING BLIND
IMPORTANT SAFETY INFORMATION
CO
h

Set Up Take Down
1) Remove Tent from
Bag and set Hub End
on ground. (Fig. 1)
2) Unfold Tent
(Fig. 2)
3) Jerk up hard on Top Hub so it pops up. (Fig. 3)
Fig. 2
Fig. 3
4) Pull out Side Hub while pushing
against Top Center. (Fig. 4)
5) Pull out remaining Side
Hubs. (Fig. 5)
6) Install Anchors as needed.
1) Remove Anchors, Push in on
Side Hub so it pops in. (Fig. 7)
2) Push remaining Side
Hubs in. (Fig. 8)
3) Push Top Hub down. (Fig. 9)
Fig. 10
4) Fold all corners up. (Fig. 10) & (Fig. 11)
5) Put tent into Bag with Hubs at the Bottom of Bag. (Fig. 12)
Fig. 9
Push
Fig. 12
Shoulder Carry Straps
Fig. 11
Fig. 1
Fig. 4
Push
Pull
Fig. 7
Push
Fig. 6
Fig. 5
Push
Pull
Fig. 8
Push