Sharp AF-Q100VX User manual

AF-Q100VX
AF-Q120VX
AF-Q100VX, AF-Q120VX)
15%
FOR YOUR PROTECTION............................... 2
CONSUMER LIMITED WARRANTY ................ 3
INSTALLATION INSTRUCTIONS
CHECK WINDOW AREA .............................. 4
LOCATION.................................................... 4
ACCESSORIES ............................................ 5
SUGGESTED TOOLS .................................. 5
INSTALLATION............................................. 6
PRECAUTIONS ................................................ 9
USING YOUR AIR CONDITIONER .................. 11
CLEANING AND MAINTENANCE ................... 16
BEFORE CALLING FOR SERVICE ................. 17
This INSTALLATION AND OPERATION MANUAL explains the proper use of your new Sharp Air Conditioner.
Read these instructions carefully before installing or operating your air conditioner. The INSTALLATION AND
OPERATION MANUAL should be kept in a safe place for handy reference.

AF-Q100VX, AF-Q120VX Room Air Conditioner. Be sure to have this

68
must be 15 1/2" (394mm)
25 1/4" (641mm)

Right
accordion
panel
Foam top
window gasket
Window
sash seal
Left
accordion
panel
Type A (6) Window locking Frame locking
bracket (1)
bracket (1)
Remote Control

Use protective material to prevent damage to
the surface.
Install the accordion panels on each side.
A. Locate the accordion panels in the box.
B. Gently pull the free end of the accordion
panel (See FIG. 1). Do this for both panels.
C. Slide the free end of the accordion panel
into the slot on the the side panel of the air
conditioner (See FIG. 1). Do this for each
side. The accordian panel labeled “LEFT”
goes on the left side of the air conditioner
as you are facing the control panel. The
accordion panel labeled “RIGHT” is should
be installed on the right side.
D. Once the accordion panels are slid into place, make sure you leave enough space to slip
on the top and bottom rails. Now, slide the top and bottom of the side panels inside top
and bottom rails. Adjust the panels until they fit securely inside the rails.
upper guide rail
lower guide rails
flexible screen
FIG. 1
3

Keeping a firm grip on the air conditioner carefully place the unit into the window open-
ing so the bottom of the air conditioner frame is against the window sill. Carefully close
the window behind the top rail of the unit.
Extend the side panels out against the window frame.
Front Side
Horizontal or inclined about 3° Upper guide rail
Lower guide rail
Window frame
6
Use 5 Type A screws to secure the frame of the flexible screen to the window frame
and sash.
Window frame
windowsill

7
To secure the sash in place, attaché the
right angle window lock with a Type B
screw as shown.
8
Cut Foam Seal to same width as window.
Insert foam strip in the space between the
upper and lower sashes.
Plastic window
Wooden window
Sealing strip
( without adhesive)