Sharp PN-CD701 User manual

PN-CD701 Dismantle Instruction
1
Dismantle Instruction
LCD MONITOR
MODEL
PN-CD701

PN-CD701 Dismantle Instruction
2
Table of contents
1. Scope.................................................................................................................. 3
2. Tools for dismantling............................................................................................... 3
3. Dismantle Procedure .............................................................................................. 3
4. Back covers .......................................................................................................... 4
5. Printed circuit boards ............................................................................................. 5
6. Battery................................................................................................................ 6
7. LCD Module .......................................................................................................... 7
8. Capacitors............................................................................................................ 8
9. Parts List ............................................................................................................. 9

PN-CD701 Dismantle Instruction
3
1. Scope
This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU.
2. Tools for dismantling
Below tools are required to dismantle this product.
- Screw Driver
- Nipper
3. Dismantle Procedure
This product can be dismantled by below steps.
1. Remove Back covers (section 4)
2. Remove the shielding.
3. Remove Printed circuit boards (section 5)
4. Remove Battery (section 6)
5. Dismantle LCD (section 7)
6. Remove Electrolyte Capacitors (section 8)

PN-CD701 Dismantle Instruction
4
4. Back covers
2 back covers (right/left) can be removed by screw driver.

PN-CD701 Dismantle Instruction
5
5. Printed circuit boards
All PWBs can be removed by screw driver.
Power PWB (1pcs) LED Driver PWB (1pcs) Pre scaler PWB (1pcs)
Scaler PWB (1pcs) T-CON PWB (1pcs) Side IO PWB (1pcs)
SOC PWB (1pcs) Audio PWB (1pcs) Top IO PWB (1pcs)
Service port PWB (1pcs) Touch DBE PWB (1pcs) Touch AFE PWB (1pcs)

PN-CD701 Dismantle Instruction
6
Front USB PWB (1pcs) Wi-Fi module PWB (1pcs) Source LED PWB (4pcs)
Win button + mic-array PWB (1pcs) Key PWB (1pcs)
6. Battery
This model uses only CR2032 Lithium Coin battery on Pre scaler PWB.
Battery CR2032 can easily be removed from the battery holder.

PN-CD701 Dismantle Instruction
7
7. LCD Module
- LCD Dismantle procedure
Due to direct bonding technology the front glass cannot be removed from the LCD.
After you have removed the PWB´s please take out the cables from the LCD module.
LCD

PN-CD701 Dismantle Instruction
8
8. Capacitors
Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB.
These capacitors can be removed by using nipper to cut the leads.

PN-CD701 Dismantle Instruction
9
9. Parts List
Parts described in Annex VII of directive 2012/19/EU are as below.
Parts
Note
LCD
70inch LCD module
Printed Circuit Boards
Power PWB
LED driver PWB
Pre scaler PWB
Scaler PWB
T-CON PWB
Side IO PWB
SOC PWB
Audio PWB
Top IO PWB
Service port PWB
Touch DBE PWB
Touch AFE PWB
Front USB PWB
Wi-Fi module PWB
Source LED PWB
Win button + mic-array PWB
Key PWB
Battery
Lithium Coin Battery CR2032
Electrolyte capacitors
(height >25mm, diameter >25mm)
On Power PWB
External electric cables
2 kinds of Power Cord
- CEE 7 (for EU)
- Type-BF (for UK)