shopPOPdisplays 13211 User manual

ASSEMBLY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE YOU BEGIN. DO NOT JUMP AHEAD OF ANY STEP.
shopPOPdisplays makes no claim that these assembly instructions cover all details, conditions or variations, or that they cover all possible contingencies in connection with the assembly or installation of
this product. It is the Purchaser's responsibility to ensure that all components of this product are properly assembled and installed in accordance with these instructions. shopPOPdisplays assumes no
obligation or liability on account of any third-party recommendations, opinions or advice as to the assembly or installation of this product.
page
1
of
2
Modular Table System
PARTS LIST:
Clear Panel
(4 pcs)
STEP 2:
Take
one panel and
stand it up on
its long edge.
Attach X-
connector to
long edge of
clear panel,
firmly pressing
down on it to
make sure it is
fully engaged
with panel.
STEP 4:
Stand assembled
panels upright on flat
surface. Insert another clear
panel into one of the open
slots in X-Connector. Start
by angling the top part of
panel into X-connector,
then push bottom corner
into bottom of connector.
Lastly, push the long edge
of panel firmly towards X-
connector and make sure
panel is fully engaged with
channel in X-connector.
H-Connector
(1 pc)
*NO TOOLS REQUIRED
*TWO PERSON ASSEMBLY RECOMMENDED
STEP 1:
Peel off the protective plastic film from both sides of clear panels.
X-Connector
(1 pc)
STEP 3:
Lay
panel down
on flat surface.
Insert another
one of the
clear panels
into the X-
connector
perpendicular
to the panel
already
installed.
Angle
top in
Push
bottom in

ASSEMBLY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE YOU BEGIN. DO NOT JUMP AHEAD OF ANY STEP.
shopPOPdisplays makes no claim that these assembly instructions cover all details, conditions or variations, or that they cover all possible contingencies in connection with the assembly or installation of
this product. It is the Purchaser's responsibility to ensure that all components of this product are properly assembled and installed in accordance with these instructions. shopPOPdisplays assumes no
obligation or liability on account of any third-party recommendations, opinions or advice as to the assembly or installation of this product.
page
2
of
2
Modular Table System
STEP 5:
Repeat process in STEP 4 for attaching
remaining clear panel.
ASSEMBLY COMPLETED
13211 / 13213 / 13215
NOTE:
Attach supplied H-connector to an open long edge of one of the panels
to connect multiple units together.
13212 / 13214 / 13216
Divider Kit Add-On
NOTE:
Optional Divider Kits may also be purchased to create additional configurations:
H-Connector