ShowTex EASYDRAPE User manual

EASYDRAPE
MAKING A DOME

Create unlimited EasyDrape congurations using these dierent parts.
COMPONENTS
8X
8X 8X
8X16X
1X
1X
24X8X 24X8X
02
EasyDrape Installation Manual

[1] Attach the base plate connectors to the base plates
and position eight EasyDrape base plates at the desired distance apart.
When positioning the base plate connectors in the base plates, make sure the two holes
in the sides of the connector are lined up in the same direction as the small markings in
the base plate.
ASSEMBLY
[tooltip]
use the EasyDrape Tool to
screw the base connectors
into the base plates
03
EasyDrape Installation Manual

[2] Attach the Uprights to the plates and the four way adaptor piece to the Uprights
Hammer the pin into the larger of the two holes in the upright.
ASSEMBLY
[tooltip]
use the EasyDrape Tool
to hammer in the pins
04
EasyDrape Installation Manual

[3] Secure the four way adaptor pieces and the Uprights
Use a safety R-spring to secure the Uprights to the plates and the base plate connectors
to the Uprights.
ASSEMBLY
05
EasyDrape Installation Manual

[4]
Attach the horizontal drape support to the four way adaptor piece of each Upright
Hinges are tted to both ends of the horizontal drape support thus enabling the end-user
to assemble one side of the EasyDrape by him/herself while the other side rests on the oor.
[slide]
ASSEMBLY
[push]
06
EasyDrape Installation Manual

[5] Extend the EasyDrape assembly horizontally to the desired width
Don’t forget to loosen the screw when extending the drape support.
ASSEMBLY
07
EasyDrape Installation Manual

[7] Attach a Half Conical Coupler and a Fibre Rod Adaptor to all the Uprights.
Use the EasyDrape Tool to screw the pin through the coupler into the four way adaptor piece.
ASSEMBLY
[tooltip]
use the EasyDrape Tool to
screw the pin in
08
EasyDrape Installation Manual

ASSEMBLY
[8] Attach a Fibre Rod Adaptor to the Uprights.
Use the EasyDrape Tool to hammer the pin into the larger of the two holes in the adaptor.
Use a safety R-spring to secure the Fibre Rod Adaptor to the Uprights.
09
EasyDrape Installation Manual

ASSEMBLY
[10]
One by one insert the Fibre Rods into the EasyDrape Fibre Disk.
Position the Fibres on top of the horizontal drape supports to attach your fabric it.
10
EasyDrape Installation Manual

[11]Two by two, push the opposed Fibre Rods to the middle of the dome, bending them
upwards. And connect them to aFibre Rod Adaptor.
ASSEMBLY
PUSH UP
& ATTACH
11
EasyDrape Installation Manual

•For more technical assistance please contact your local ShowTex office.
TROUBLE SHOOTING
12
EasyDrape Installation Manual