Siamp Optima 50 User manual

OPTIMA 50
ASSEMBLY INSTRUCTIONS
Button
Short flush
Long flush
Optional escutcheon
(not always supplied)
Button nut
Dead water
sliding valve
Strainer
Strainer nut
Pan gasket
Strainer gasket
Valve gasket
Overflow
Réf. 50 5531 00 B
a
b
c
e
f
g
h
i
j
l
Short
flush cursor k
Cable d
N 50N 100
GB

II - ASSEMBLING BOWL AND CISTERN
Fix screws at the bottom of the cistern
(see order of parts below)
Position the latex foam gasket on the nut (g)
Position the cistern on the bowl and secure it with wing nuts
I - INSTALLATION
Position the mechanism in the cistern
and secure it in place with the nut (g)
Manually screw the ush valve nut (g)
until it is in contact with the ceramic.
If necessary give an extra quarter
turn (maximum) with the appropriate
spanner.
NB : Excessive tightening can damage
the mechanism and would not be
covered by the guarantee.
Bottom of cistern
Wall of bowl
Conical seal
Hexagon nut
Washer
Wing nut
Washer
M6x78 screw

III - INSTALLATION OF BUTTON
IV - MAINTENANCE
Changing the valve gasket
After having opened the cistern,
turn the mechanism 90° to
separate it from its strainer
Change the valve gasket
Reposition the mechanism,
locking it into the strainer
Close the cistern again.
Valve gasket
Strainer
Once the set-up has been completed, place button (a) on lid and screw button nut (c),
(if the hole in the lid (D) is > 38 mm and < 45 mm, remove the escutcheon (b))
Clip cable case
Place lid back on top of cistern

Fiber gasket
INSTALLING THE FLOAT VALVE
ROBECO 06 and STANDARD 15EL
MAINTENANCE (95L & 99B)
4, quai Antoine 1er - BP 219 - MC 98007 MONACO Cedex
Tél. [phone] - Fax : [phone] - E-mail: [email protected]
Position valve
Fasten with nut
Connect to water supply
Adjust water level with the adjustment screw
Position valve
Fasten with nut
Connect to water supply
Adjust water level with the adjustment screw
(15 EL) or by bending the rod (06)
COMPACT 99B and HANDY 93B
COMPACT 95L
Adjustment screw
Insert rod
as far as
possible Locking nut
Fiber gasket
Adjustment screw
Locking nut
Fiber gasket
Adjustment
screw
Locking nut
Locking nut
Gasket/lter
Adjustment screw
Filter
Membrane
Membrane
Manually screw the backnut until it is in contact with the
ceramic. If necessary give an extra quarter turn (maximum).
N.B.: Excessive tightening can damage the mechanism and
would not be covered by the guarantee.
Ensure tightness of connection to cistern with lter gasket.
WARNINGS:
1 - Do not overtight in any case.
2 - Do not use any sealing paste and/or compound in any case
SIAMP will be not responsible in case these warnings are
not respected.
N 50N 100
Siamp Ltd / Unit C2 / Meadowbank Business Park
Tweedale Way / Hollinwood / Oldham / Greater Manchester / OL9 8EH
Telephone : [phone] / Fax : [phone] / [email protected]
For 99B and 95L inlets, an approved single check valve or some other no less effective backow prevention device shall be
tted at the point of connection(s) between the supply and the tting.