Sielox Class Series User manual
Sielox Class and AnyWare Quick Start Guide
A. On your desktop PC or laptop, set the Local Area Connection IPV4 settings.
1. Click on the Start icon on the lower left hand corner on a Windows operating system.
2. In the Search programs and files box type Network and Sharing Center window and then click the link
3. Click on Local Area Connection.
4. Click on Properties.
5. Select Internet Protocol Version 4 (TCP/IPv4) and then click on Properties.
6. Select Use the following IP address: and enter 192.168.1.XXX in the IP Address (choose an IP address
not already in use). The Subnet Mask will default to 255.255.255.0, leave the Gateway blank and click
OK.
1.
2.
3.
4.
5.
6.
-More-
Quick Start Guide Continued…
B. Next, connect & power up the appliance.
7. Connect an Ethernet cross over cable from your computer to the left Ethernet port on the appliance.
8. Plug the power into the appliance and turn on the power by pressing the button on the front panel.
9. Verify connectivity between the appliance and computer. Make sure you can ping the appliance at
address 192.168.1.251 and that you get a reply.
C. Now that you’re connected, log into Sielox Class or AnyWare.
10. Open a browser on the computer and type in 192.168.1.251 in the address bar.
11. This should bring up a “certificate error”, click accept/continue. Note: You may need to add an
exception to your browser.
12. Once the Sielox Class or AnyWare Login page is displayed, log in using the default credentials,
Username: admin Password: admin.
Class 50/100 & AnyWare 40:
9
.
7.
10.
11.
11.
11.
12.
8.
7.
7.
AnyWare 8:
Class 300:
192.168.1.251
This manual suits for next models
3
Table of contents
