Sierra Innova-Sonic 205 Programming manual

Innova-Sonic® Model 205 Quick Start Instructions
1
ˊ
Operation of Keyboard (Figure1-1)
0~
9are the menu codes to input information
required for the flow measurement exercise.
You can use
Ż to delete or move back to the
previous data.
Ʒ / + ~  / - are to toggle up and down the
menu.
After all data is selected, press
ENT to confirm.
MENU is used to select a menu using two-digit
numbers for each menu. For example, to enter pipe
outside diameter, select
MENU 1 1to enter into the window (ĀMENU11āis the address
code of the outer pipe diameter).
2
ˊ
Transducer Connection˄Figure2-1˅DŽ
(11)GND--PE ˄18 Ground ˅-˄DN˅screen wire ˄21 Ground ˅-˄UP˅screen wire
(12)L-- AC ˄19 Conductor˅- (DN) red wire-core ˄22 Conductor˅- (UP) red wire-core
(13)N --AC˄20 Shield Layer˅- (DN) black wire-core ˄23 Shield Layer˅- (UP) black wire-core
Note˖The upstream transducer cable is coded red and the downstream is blue.
Figure˄2-1˅Connection of the flow meter’s transducers
3
ˊ
Measurement Site Selection ˄Figure2-2˅
Figure2-2 Installation at the 3 o’clock and 9 o’clock positions
Figure1-1 Keyboard

Select the measurement site on a straight section of pipe with 10D (10 pipe diameters)
upstream and 5D downstream. The transducers usually are installed at the site
3 o’clock and 9 o’clock positions, and avoid installation at 6 o’clock and 12 o’clock.
4
ˊ
Installation and Debugging
Using this quick start installation procedure, the basic parameters needed for a quick startup can
be easily done (inputs, such as the pipe outside diameters, pipe wall thickness, pipe material, fluid
type, method of transducer installation, etc.). Also the distance (spacing) between the upstream
and downstream transducers is automatically calculated by the flow meter in order to obtain the
ultrasonic signal and to measure the flow. The main installation and debugging process as follows:
1
˖
Power up the flow meter electronics
2: Select MENU 1 1 and enter the outside pipe diameter
3
˖
Select
MENU 1 2 and enter input the pipe wall thickness
4
˖
Select
MENU 1 4 and choose the pipe material

5: Select MENU 2 0 and choose the fluid type
6: Select
MENU 2 4 and choose the transducer mounting method
7: Select
MENU 2 5 and see the calculated transducer spacing
8: Use the calculated data for transducer spacing for installation
8.1 Pipe orientation and preparation (cleaning)

8
ˊ
2 Applying coupling grease and mounting transducers
9: Select
MENU 9 0 and see the signal strength of the installed transducers.
(When the UP and DN signal strength is at least 60, the signal quality is at least 50, the flow meter
is functioning well.)
10:Select
MENU 9 1 to check TOM/TOS*100, (it should be 100f3% )

11: Select MENU 0 0 to read the instantaneous and totalizing flow.
12: Select
MENU 9 5 and setup the data collection interval of SD card.
Note:
The information presented above is for quick start-up of the Sierra Innova-Sonic®
Model 205. Other setup parameters are referenced in the 205 manual.
For insertion transducer go to Innova-Sonic® Model 205 Manual
Appendix 4.
Edited 10/11/2009