SIGLENT SDS1000CML+ User manual

User Manual
SDS1000CML+/SDS1000DL+
Digital Oscilloscope
UM0101A-E01A
SIGLENT TECHNOLOGIES CO,.LTD

SIGLENT
SDS1000CML+/SDS1000DL+ User Manual I
Declaration
Copyright © by SIGLENT TECHNOLOGIES CO,.LTD. All rights reserved.
Contents in this Manual are not allowed to copy, extract and translate
before being allowed by SIGLENT.

SIGLENT
II SDS1000CML+/SDS1000DL+ User Manual
Brief Introduction
Characteristic:
● The volume of the oscilloscope is cabinet and it is portable
● 7” Color TFT LCD display
● 2 channels, Bandwidth: 40MHz-150 MHz
● Single real-time sampling rate is: 1Gsa/s;
Equivalent sampling rate is 50GSa/s.
● Trigger types: Edge, Pulse, Video，Slope and Alternative
● Unique Digital Filter function and Waveform recorder function
● Auto measure thirty two parameters and support all measurement
function.
●Two groups’ reference waveforms and twenty groups’ capture
waveforms and twenty groups’ setups internal save/recall function
and USB flash drive save/recall function.
● Cursor types: Manual mode, Track mode and Auto mode.
● Channel waveform and its FFT waveform display on split screen.
● Waveform Intensity and Grid Brightness can be adjusted.
● Menu display in the form of pop-up that in order to convenience users to
use it.
● Rich Screen display styles: Classical, Modern, Tradition, Succinct.
● Multiple Language User Interface.
● Support Multilingual online help system
●Standard interface: USB Host, USB Device, LAN port
Standard Accessories:
● 1:1/10:1 probe (2 PCS)
● Power Cable that fits the standard of destination country
● Qualified Certification.
● CD (including EasyScopeX computer software system)
● Quick Start
● USB Cable

SIGLENT
SDS1000CML+/SDS1000DL+ User Manual III
General Safety Summary
Carefully read the following safety precautions to avoid person injury and prevent
damage to the instrument and any products connected to it. To avoid potential
hazards, please use the instrument as specified.
Only qualified technician should perform service procedures
To Avoid Fire or Personal Injure
Use Proper Power Line
Use only the special power line of the instrument which approved by local state.
Ground the Instrument
The instrument grounds through the protective terra conductor of the power line.
To avoid electric shock, the ground conductor must be connected to the earth.
Make sure the instrument is grounded correctly before connect its input or output
terminals.
Connect the Signal Wire Correctly
The potential of the signal wire is equal to the earth, so do not connect the signal
wire to a high voltage. Do not touch the exposed contacts or components.
Look Over All Terminals’ Ratings
To avoid fire or electric shock, please look over all ratings and sign instruction of
the instrument. Before connecting the instrument, please read the manual
carefully to gain more information about the ratings.
Not Operate with Suspected Failures
If you suspect that there is a damage of the instrument, please let a qualified
service personnel check it.
Avoid Circuit or Wire Exposed Components Exposed
Do not touch exposed contacts or components when the power is on.
Do not operate in wet/damp conditions.
Do not operate in an explosive atmosphere.
Keep the surface of the instrument clean and dry.