Signtex Lighting Moonlite LED MHE-AC-ST Series Manual

Wet Location
Series MHE-AC-ST
Moonlite LED™
High Output Emergency Light
Installation Instructions & Users Manual
REV 5.17.00
1. Disconnect AC power before servicing.
2. Refer to wiring diagram for proper connections.
3. All servicing should be performed by qualified personnel.
4. Consult your local building code for approved wiring and
installation.
5. Do not use this equipment for other than intended use.
6. Do not let power cords touch hot surfaces.
7. Mount and secure the fixture at a location and height
to avoid ready access and tampering by unauthorized
persons.
8. The use of accessory equipment is not recommended by
the manufacturer and may cause an unsafe condition.
9. Suitable for wet locations. See product label for temperature
limitations.
IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1. Identify mount position and install 4” x 4” LIQUID TIGHT J-Box near to fixture.
2. Connect wiring: BLACK- 120 VAC LINE
WHITE- NEUTRAL
ORANGE- 277 VAC LINE
GREEN- GROUND
3. Install screw anchors in mounting surface for (4) #8-32 screws to match holes provided in
Bracket or Housing.
4. Remove Lamp Assembly and install (4) #8-32 screws to secure Bracket or Housing in position.
5. Secure lamp assembly to bracket with screws provided and route lamp cable through opening
in end of bracket. Insert lamp cable through liquid tight bushing into LIQUID TIGHT j-box.
6. Connect RED lamp wire to POSITIVE power input circuit and BLACK lamp wire to COMMON
NEGATIVE power input circuit with standard wire nuts.
CHECK CONNECTIONS BEFORE SUPPLYING POWER :
REVERSE POLARITY WILL PERMANENTLY DAMAGE FIXTURE
7. Supply power to check lamp operation.
CEILING
BRACKET BUSHING
CONDUIT
LAMP CABLE
LIQUID TIGHT
OUTLET BOX
120/277
VAC IN
B
B
R
R
L
N
G
12" MAX
SURFACE OPEN MOUNT
LAMP
ASSBY
(2) 8-32 X 3/8"
HEX HD SST
POWER
SUPPLY

Wet Location
Series MHE-AC-ST
Moonlite LED™
High Output Emergency Light
REV 5.17.00
-2-
220 VFW Avenue, Grasonville, MD 21638
TEL: [phone] Fax:[phone]
[e-mail] www.signtexinc.com
Signtex Inc
LIGHTING
ALTERNATE MOUNT
CEILING
BRACKET
GASKET
LAMP ASSBY
(2) 8-32 X 3/8"
HEX HD SST
(2) 8-32 X 1"
1. Identify mount position and install 4” x 4” LIQUID TIGHT J-Box near to fixture.
2. Connect wiring: BLACK- 120 VAC LINE
WHITE- NEUTRAL
ORANGE- 277 VAC LINE
GREEN- GROUND
3. Install screw anchors in mounting surface for (4) #8-32 screws to match holes provided in
Bracket or Housing.
4. Remove Lamp Assembly and install (4) #8-32 screws to secure Bracket or Housing in position.
5. Secure lamp assembly to bracket with screws provided and route lamp cable through gasket
in top of bracket. Insert lamp cable through liquid tight bushing into LIQUID TIGHT j-box.
6. Connect RED lamp wire to POSITIVE power input circuit and BLACK lamp wire to COMMON
NEGATIVE power input circuit with standard wire nuts.
CHECK CONNECTIONS BEFORE SUPPLYING POWER :
REVERSE POLARITY WILL PERMANENTLY DAMAGE FIXTURE
7. Supply power to check lamp operation.
LAMP CABLE
LIQUID TIGHT
OUTLET BOX
120/277
VAC IN
B
B
R
R
L
N
G
POWER
SUPPLY