Silent Gliss 0997 User manual

1
-Motors are delivered to SGGB in ‘Programming’ mode
-Motor limits are then set approximately during production (as normal)
- Limits can be reset on site either by 0997 test lead or by 9940 series wireless
switches or handsets (wireless motors only)
-A 0997 test lead will be required if non radio control type
-Please note when adjusting or re-setting limits both the up and down limits must be
reset - individual limits cannot be set independently
Set Limit Positions using 0997 Setting lead

Foot note optional - Arial regular 9pt 2

3
Changing / Erasing Limit Positions
1. Drive blind to approximately mid
position – thereby determining the
direction of movement of the blind on
the switch (you must allow at least
30cm of movement to the nearest limit
setting position).
For integrated motors now unplug from
the supply for 1 – 2 seconds and then
re-connect.
2. Press the up and down buttons on the
test lead (or handset) together, after
approx. 5 sec. motor will respond with a
short up and down movement.
⇒Limits are erased. Motor is now in
limit setting mode

4
Setting Limit Positions – Limits can be set in either direction at this stage the
instructions below start with the setting the down limit first.
3. Hold the down button until motor ‘jolts‘
and increases speed then continue
pressing down button until blind is at
required position.
(To get to an accurate limit position
release the button and pulse in the
same direction with the same button in
small movements).
4. Press and hold the up button until motor
stops automatically (approx 30 cm
movement).
Release the up button
⇒Lower position is set

5
Setting Limit Positions - continued
5. Hold the up button until motor ‘jolts‘ and
increases speed then continue pressing
down button until blind is at required
position.
(To get to an accurate limit position
release the button and pulse in the
same direction with the same button in
small movements).
6. Press and hold the down button until motor
stops automatically (approx 30 cm
movement).
Release the down button.
⇒Both limits are set