Silentnight Hamilton User manual

Pre - assembly Preparation
customer services
on 01244 689949.
30

Wooden Slats x 28
Centre Rail x 1
E
F
G
M6 x 50mm Bolt
x 8
10 x 40mm Dowel
x 8
Cap Ends
x 28
Slat Connectors
x 14
Centre Rail Cup
x 2
M4 x 20mm Screws
x 8
Allen Key
2

Step by step assembly instructions
Step One
1
2
E
E
F
F
Attach the Centre Rail Cup (E) to the pre-drilled holes on the lower rail of the Headboard (1)
and Footboard (2), using M4 x 20mm Screw (F) as shown in the diagram below.
3

Step Two
Place the 10 x 40mm Dowels (B) into the pre - drilled holes on each end of the Side Rails (3).
Attach the Side Rails (3) to the Headboard (1) and Footboard (2) using M6 x 50mm Bolts (A)
and tighten using Allen Key (G) as shown in the diagram below.
A
A
3
1
3
2
1
A
AB
B
A
A
B
B
3
A
A
B
B
A
A
B
B
Ex 4
Step Three
4
2
1
3
3
1 & 2
4
1
Lower the Centre Rail (4) onto the Centre Rail Cups (E) on the Headboard (1) and Footboard (2) as shown in the
diagram below.
E
4

Step Four
Starting at the Headboard (1), attach the Slat Connectors (D) into the pre - drilled holes along
the Centre Rail (4). Ensuring the Wooden Slats (5) are facing curved side up, place a Cap End (C)
onto the end of the Wooden Slats (5). Insert the other Slat (5) end into the Slat Connectors (D)
then push the end with the Cap End (C) into the pre - drilled holes along the Side Rails (3).
Repeat this process for all of the Wooden Slats (5).
D
C
5
4
3
This bed is now ready to use.
5

Wooden Bed
6
I