
GB│IE │ 7 ■
SMK 1000 B3
5) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
6) Press the MODE button qrepeatedly until the
programme indicator for the programme you
want to use starts to flash.
–PUREED SOUP wfor creamy, pureed
soups
–CHUNKY SOUP efor chunky soups.
7) Press the START/STOP button i. The appli-
ance beeps. The programme indicator of the
selected programme lights up permanently.
Preparation of the soup now takes place automat-
ically. The appliance heats and mixes at regular
intervals.
NOTE
► You can stop the preparation process at any
time by pressing the START/STOP button i
(for about 2 seconds, until you hear a beep).
As soon as the preparation process is complete,
the appliance will stop automatically. The appli-
ance will beep and the relevant programme indica-
tor of the set programme flashes.
8) If you do not want to serve the soup immediately,
you can activate the keep-warm function: Use
the MODE button qto select the programme
KEEP WARM uand press the START/
STOP button ito start the programme.
After 60 minutes, the appliance stops automati-
cally. You can stop the keep-warm process at
any time by pressing and holding the START/
STOP button i.
9) Remove the plug from the mains power socket
and the connector 3from the built-in plug 4.
Remove the lid 9carefully from the blender
jug 5and place it to one side.
WARNING! RISK OF INJURY!
► Be careful when opening the lid 9.
Hot vapour can escape! We recommend the
use of oven gloves.
You can now serve the soup in bowls or a soup
terrine.
NOTE
► Clean the appliance after every use (see
section "Cleaning and care"). Otherwise resi-
dues from the previous cooking process that
may be left on the bottom of the container
could burn.
Preparing compote
1) Cut the fruit/vegetables into pieces of around
2 cm and place these in the blender jug 5.
2) Fill the blender jug 5up to no more than the
MAX - 1600 ml marking with water or other
liquids. Always fill up to at least the MIN -
1300 ml marking!
3) Place the lid 9on the blender jug 5. Ensure
that the contact plug 1in the lid 9fits cor-
rectly in the safety socket 2.
4) Insert the connector 3into the built-in plug 4
on the appliance.
5) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
6) Press the MODE button qrepeatedly until the
COMPOTE programme indicator rstarts
to flash.
7) Press the START/STOP button i. You will hear
a beep and the COMPOTE programme indica-
tor rflashes.
Preparation of the compote now takes place auto-
matically. The programme runs for 13 minutes.
NOTE
► You can stop the preparation process at any
time by pressing the START/STOP button i
(for about 2 seconds, until you hear a beep).
As soon as the preparation process is complete, the
appliance will stop automatically. You will hear
a beep and the COMPOTE indicator light r
flashes.