GB│IE │ 7 ■
SPM 220 A1
Assembling the appliance
NOTE
► Before first use, clean all parts of the appliance
as described in the section Cleaning.
1) Set up the appliance on a flat surface near a
mains socket that is easily accessible. There
should be enough space in front of the appli-
ance for a bowl or similar to catch the pasta.
2) Push the dough containertinto the appliance
base5as far as the stop. The tabs on the
dough containertmust be pushed into the
corresponding slots in the rear wall.
3) Guide the kneading hook9 into the dough
containertfrom above and insert it into the
drive shaft6.
4) Push the supportqinto the end of the
bracketwso that the three tabs on the
supportqslide into the grooves on the
bracketw(fig. 3).
0
q
w
9
Fig. 3
5) Mount the bracketwonto the dough
containert. Push in the bracketwso that its
narrow end goes through the round opening
on the dough containert (fig. 3).
The bracketwonly fits into the opening in one
position; the markingemust point towards
the symbol on the dough containert.
Turn the bracketwclockwise until the
markingeon the bracketwpoints to the
symbol (fig. 4):
w
e
Fig. 4
6) Then push the dough shaft0with its narrow
end through the bracketwinto the retainer
on the kneading hook9 (fig. 3). If necessary,
reach into the dough containertfrom above
and wiggle the kneading hook9a little until
you can push in the dough shaft0.
7) Place the front panelzonto the dough
containertand push it firmly into place. The
catches on the front panelzmust slide into in
the corresponding recesses on the dough
containert.
8) Select the appropriate shaping disc8(see
section Shaping discs) and slide it onto the
bracketwso that the two catches on the
shaping disc8slide into the recesses on the
bracketw.
9) Push the shaping disc fixtureronto the
bracketwand tighten it by turning it clockwise
towards the symbol. Fix the shaping disc8
in place with your free hand if necessary.
10) Do not fit the lid 2 until after you have placed
the required amount of flour in the dough
containert(see section Making pasta).
11) Insert the plug into an easily accessible mains
socket. You will hear a beep and the display a
lights up briefly. The appliance is now in
standby mode.
The appliance is now assembled and ready for
operation.
