10 GB/IE/NI/CY
Start-up / Cleaning and Care / DisposalImportant safety instructions / Before Initial Use / Start-up
Discontinue use of the hot air
brush it it has been dropped or
otherwise damaged.
Untangle the supply cable 10 if
twisted.
Do not use accessories not rec-
ommended by the manufacturer
or offered as accessories.
Repairs may only carried out only
by qualified specialist personnel
or in a workshop approved by
the manufacturer. Improper re-
pairs may result in considerable
danger for the user.
Before Initial Use
Note: Immediately switch off the device if defective
or malfunctions occur.
Note: Hairspray contains flammable substances.
Do not use hairspray whilst operating the hot air
brush.
Wash and groom your hair as usual.
Stand on a dry, non-conductive floor.
Ensure your hands are dry.
Untangle the supply cable 10 if twisted.
Do not pull, twist or kink the supply cable 10 ,
and do not run across/place on sharp, pointy
objects or hot surfaces.
Do not crush the supply cable 10 in e.g. draw-
ers or doors.
Start-up
Towel dry your wet hair and comb it thoroughly.
Allow your hair to dry fully at the roots and
partly along the sections before styling.
Use the styling nozzle 14 to dry the hair.
The 40 mm thermal volume brush 12 adds vol-
ume and fullness to your hair at the roots. The
brush can also be used to style the ends of long
hair and to straighten curls.
First select an attachment 12 , 14 before switch-
ing on the device. Secure the attachments to
the handle 6by aligning the dot above the
release button 11 on the handle 6and turn
to the left to lock in place.
To change the attachments 12 , 14 , press the
release button 11 and turn the attachment to
the right.
Insert the mains plug into the socket.
Divide your hair before styling it. First style the
bottom layer of hair.
Select the desired heat and blower setting using
the sliding switch 5. Select from the following
functions:
0 Off
Cool air
1 Medium temperature and airflow
2High temperature and airflow
Using the hair curler
attachment
Attach the hair roller attachment 1to the han-
dle 6by aligning the dot above the release
button 11 on the handle 6and turn to the left
to lock in place.
Select the desired hair roller size and slide the
hair roller 13 onto the hair roller attachment 1.
Press the lock/unlock lever 2and push the
roller 13 onto the handle (you may need to
slightly turn the roller). Release the unlock/
lock lever 2and the hair roller 13 will firmly
lock in at the edge.
Take a 2.5cm wide section of hair and hold it
tautly up or or sideways away from the head.
Continue holding the section of hair taut and
wrap the ends of hair around the self-grip sec-
tion 15 of the hair roller 13 .
Turn the grip 6and wrap the hair around the
hair roller 13 , not yet switching on the heat
function. Be sure the ends are wrapped.
