Simon 70E850TY 70E85ITY User manual

2 Gang Smart Easy Switch(no neutral)
Basic Information
Range E3 smart
Type Smart Switch (Easy Switch)
Finishing White
Communication ZigBee
Highlights No extra wiring,retrofit in original 86 wall box
Same wiring method with traditional switch
Scenes and automation with other smart devices
ZigBee 3.0,safe and reliable hardware
Remote control on/off,Timer/Indicator setting
无
无
Product Information
Norminal Voltage 250V~50/60Hz
Operational Voltage 176VAC-264VAC
Load >3W,200W/Gang
无
无
无
无
无
无
无

无
无
无
Installation and Maintenance
IP protection IP20
Material PC (polycarbonate)
Operatingtemperaturerange -10°C~40°C
Installationtype wall mounted
无
无
无
无
无
无
无
无
无
无

Simon-Smart Installation Manual
1Network Environment
1.1 Basic Requirement for Network
Wi-Fi —Home Router
Support 2.4GHz Wi-Fi, select 2.4GHz Wi-Fi signal
2.4G/5G combination Wi-Fi is not supported
Can check the Wi-Fi type on the mobile phone or PC
ZigBee —Smart Gateway
Need to be connected with home router via network cable or Wi-Fi
Connect ZigBee devices to internet

Simon-Smart Installation Manual
3Smart Easy Switch
3.1 i7/E6/M3/E3 Easy Switch (no neutral)
Code
Description
70E850TY
1 Gang Smart Easy Switch Module
70E851TY
2 Gang Smart Easy Switch Module
70E852TY
3 Gang Smart Easy Switch Module
72E8031TY
1 Gang Smart Easy Switch
72E8032TY
2 Gang Smart Easy Switch
72E8033TY
3 Gang Smart Easy Switch
58E8031TY
1 Gang Smart Easy Switch
58E8032TY
2 Gang Smart Easy Switch
58E8033TY
3 Gang Smart Easy Switch
30E831TY
1 Gang Smart Easy Switch
30E832TY
2 Gang Smart Easy Switch
30E833TY
3 Gang Smart Easy Switch
Installation Environment:
Only Need to connect to L Line in the mounting box. No need neutral line
Preparation for Use:
Ensure that the smart gateway has been added.
Mobile phone is connected to Internet (Wi-Fi or 3G/4G/5G)
Ensure effective coverage of ZigBee network.(Communication distance
between any ZigBee devices: ＜2 walls, ＜100m in open area)
Network Configuration:
Download and open Simon Smart APP
After connecting the power, long press the left bottom button of switch
until the configuration indicator flashes

Simon-Smart Installation Manual
If not flashes or you want to reset, remove the cover and insert the pin
into the reset hole until the configuration indicator flashes
Open Simon Smart APP, enter the “Gateway” interface and click “Add
Subdevice”
Confirm that indicator is blinking, then click “LED already blink”
Add the device as per the app prompts
Configuration Indicator Status:
Waiting pairing
4 quick flashes per second
Pairing success
2 flashes per second for 2s
Pairing failure
1 flash per second for 10s
Initial power on
ON for 1s
Reset success
2 flashes per second for 2s