simplehuman ST1008 User manual

set up
guide

prime the pump
1
quick start
• use a screwdriver to
remove battery cover
• insert 4 AA batteries
as shown
• lift off the lid on top of
the chamber to fill
Note: Do not use soap
with exfoliants, and be
careful not to overfill.
insert batteries
fill the reservoir
1
2
3
• place your hand under
the sensor
• hold down button
until soap comes out
+
If the soap doesn’t flow, lightly
flick the valve opening to
release any trapped air.
Note: Only use alkaline batteries. tip: priming problem?

adjust the volume
on/off
continuous dispensing
low battery alert
To change the amount dispensed,
press or buttons at the front of
the pump.
Press and hold button to
dispense soap continuously.
LED will turn red during operation
to indicate low battery.
+-
Press and hold button to turn the
pump off, press button to turn on.
+
+
-
+
–

use & care
• Your sensor pump dispenses
soap, hand sanitizer, or lotion.
Please keep it simple: avoid
soaps with exfoliants or beads.
• To clean, wipe pump with a damp
cloth—do not submerge in water
or use in the shower.

Questions?
Find answers easily online:
www.simplehuman.com/service

a can
for any
space
We make our step cans in
many sizes and styles. Find
the one to match your space
at www.simplehuman.com
see the entire collection at www.simplehuman.com

semi-round step can plastic slim step can
butterfly step can slim step can
round step can
rectangular recycler

<tools for efficient living®
www. .com
120-0123-02