Simplex 4010 User manual

4010 FIRE ALARM SYSTEM OPERATING INSTRUCTIONS
FOLLOWING AN ALARM/TROUBLE/SUPERVISORY CONDITION
1998 Simplex Time Recorder Co.
All specifications and other information shown were current as of publication, and are subject to change without notice.
574-053
Rev. B
YOUR SAFETY AND THE SAFETY OF THOSE AROUND YOU ALWAYS COMES FIRST.
Actions taken during a fire depend upon local practices. Be sure you know what to do.
ALARM TROUBLE/SUPERVISORY
RED LED IS FLASHING AND TONE-ALERT IS PULSING
FIRE = 3 SUPERVISORY = 0 TROUBLE = 0
M1-101, -102
RED ALARM LED
(FLASHING)
ALARM
ACKNOWLEDGE
KEY
ALARM
SILENCED
LED
ALPHA-
NUMERIC
DISPLAY
ALARM
SILENCE
KEY
SYSTEM
RESET
KEY
1. Unlock and open the panel door.
Read
and follow the instructions
on the display. It will toggle between Screens 1 and 2.
SCREEN 2
2. Press the (ALARM ACK) key under the flashing red LED.
Read
the
alphanumeric display.

The tone-alert is silenced and the display shows pertinent
report information, such as shown below.
SCREEN 3
3.
Read
the Alarm information on the display. Summon appropriate
personnel to respond.
HOW TO SILENCE THE SIGNALS
4. Press the (ALARM SILENCE) key and read the display. The
alphanumeric display shows signal status.

ALARM SILENCED LED turns ON steady.
HOW TO RESET THE SYSTEM
5. When the alarm condition clears, restore or replace all affected
devices (smoke detectors, pull stations, etc.) in accordance with the
instructions provided with each device.
6. Reset the system.

Press the (SYSTEM RESET) key.
The system displays the following after a completed System
Reset with no alarms present:
7. Press any key to return to the SYSTEM NORMAL screen.
YELLOW LED IS FLASHING AND TONE-ALERT IS ON STEADY
FIRE = 0 SUPERVISORY = 0 TROUBLE = 3
* * TROUBLE * * YELLOW
TROUBLE
LED
(FLASHING)
ALPHA-
NUMERIC
DISPLAY
TROUBLE
ACKNOWLEDGE
KEY
Press ACK to review
Note: A Trouble Condition is described in this example. A
Supervisory Condition is handled in a similar manner.
1. Unlock and open panel door.
Read
and follow the instructions on
the display (see example below).
2. Press the (TROUBLE ACK) key under the flashing yellow LED.
Read
the Trouble information on the display (see example below).
3. Summon appropriate personnel to respond.
4. Response personnel should restore or replace the defective device
(switch, wire, notification appliance, etc.) in accordance with device
instructions (see the 574-709 manual for additional information on
“dirty” or “excessively dirty” troubles. Refer to 526-444 label for
appropriate publications and revisions).

If necessary, press (SYSTEM RESET) when the abnormal
condition has been corrected.

After a short delay, the system returns to normal and displays
the following.
Note: If your system configuration does not match this sheet, consult
Simplex for specific operations. Simplex is listed in the Yellow
Pages.
In case of trouble, notify:
Name
Address
Phone#
THESE INSTRUCTIONS ARE INTENDED TO BE FRAMED AND MOUNTED ADJACENT TO THE
CONTROL PANEL FOR READY REFERENCE.
See Operator's Instruction Manual for detailed operation.
SCREEN 1
Technical Manuals Online! - http://www.tech-man.com