Sizewise Platinum 6000 Series User manual

Platinum 6000™
Quick Reference Guide
Current
This is the international keypad with current
color applied.
For Rev. 2 keypad, see Part No. 27650013

Keypad Controls
Power/Standby: Power On (Green LED); Standby
(Amber LED)
Mode: Select between Therapy Modes
Autorm: max inate for transferring patient
Alternation Therapy
Alternation Therapy with Microclimate
Management/Low Air Loss
Immersion Therapy with Microclimate
Management/Low Air Loss
Immersion Therapy
Cycle Time: for Alternation Therapy only
Alarm Silence: press to reset alarms
Power Fail Warning
Low Pressure Warning
Lock/Unlock

1. Press and hold . Green LED indicates pump is on;
Amber LED indicates standby mode.
2. Press until is selected to autorm surface;
transfer patient to surface.
1. Use to select Therapy Mode.
Alternation Therapy (no Microclimate
Management/Low Air Loss)
Alternation Therapy with Microclimate
Management/Low Air Loss
Immersion Therapy with Microclimate
Management/Low Air Loss
Immersion Therapy (no Microclimate
Management/Low Air Loss)
2. Alternation mode requires a 5, 10, or 15 min. cycle.
Use to adjust.
Operating Instructions
Setting Therapy Mode

To customize the mattress for your patient, follow these three steps:
Patient Height: Select and use until patient’s
height is shown on display.
Patient Weight: Select and use until patient’s
weight is shown on display.
Comfort Settings: Select to override auto pressure
settings. Use to adjust surface’s rmness
(15mmHg to 50mmHg).
Patient Specic Adjustments

The pump’s default settings are in standard units.
Change to Metric Units:
1. Put the pump in standby by pressing .
2. Press and hold and . Keep buttons depressed
until all lights ash and you hear six beeps.
3. Cancel alarm by pressing .
4. Press to turn on.
Change to Standard Units:
1. Put the pump in standby by pressing .
2. Press and hold and . Keep buttons depressed
until all lights ash and you hear six beeps.
3. Cancel alarm by pressing .
4. Press to turn on.
Note: A decimal point in the Patient Weight screen indicates metric units.
Changing Units of Measurement

1. Locate red CPR valve at head of mattress. Turn valve for
quick air release.
2. Detach hoses from pump by pressing blue button and
pulling connector from unit.
To maintain ination during transport:
1. Ensure CPR valve is in closed position.
2. Press to put pump in standby mode (amber LED).
3. If mattress is to be disconnected from pump, place
Transport Cap over hose connections.
sizewise.com 800-814-9389
OPS-0047A-1018 27650011, Rev. 4.0
This card is not meant to replace product user
manual. For complete manual, contact Sizewise.
Patient Transport
CPR/Quick Deflation